Prorack K987 User manual

K987
Fitting Kit
EN Fitting Instructions for Basic Carrier CAUTION: Professional
installation recommended
x 4 x 4 x 4 x 8
x 4 x 4 x 4 x 1
x 1
Revision No: 1A 1

Fitting Kit K987
MAX kgs (lbs)
W/P WHD
Tata
Xenon Double Cab, 4dr Ute 09-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs)
Xenon Double Cab, 4dr Ute 09-+ ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
2

Fitting Kit K987
X
A B C 1 2 3
Xenon Double Cab, 4dr Ute 09-+ (AU) -150mm 550mm - 864mm 858mm -
-5 -7/8ths" 21 5/8ths" - 34" 33 3/4ths" -
Xenon Double Cab, 4dr Ute 09-+ (ZA) -150mm 550mm - 864mm 858mm -
-5 -7/8ths" 21 5/8ths" - 34" 33 3/4ths" -
3

Fitting Kit EN
K987
Items you will require:
●Tape measure
Pen
Flat-head screwdriver
Craft knife
Side cutters or tin snips
Hammer
8mm (3/8") punch
Cordless drill
Depth stop
Vacuum cleaner
Rust inhibitor
Small paint brush
Neutral cure silicon sealant
Rivet gun
Attention:
●Attaches with riveted mounts under rubber
ditch mould. Professional installation
advised.
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
4

Fitting Kit EN
K987
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
●Use keys to remove covers.
●Use hex screwdriver to reverse adjusting
screw 10 turns.
5

Fitting Kit EN
K987
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
●Adjust crossbar in or out to suit vehicle.
●Please check the front of this manual for
information relating specifically to your
vehicle.
●Remove plastic clamp block by gripping bar
leg with fingers and push firmly with
thumbs until clamp block drops out behind
leg.
6

Fitting Kit EN
K987
●Select plastic internal block (from fitting kit)
and insert into foot.
●Repeat for all legs.
●Fit rubber pads (supplied with fitting kit) to
foot. Pad may vary in shape to that shown.
●Make sure the pad fits into the holes
underneath the foot.
●Mark reference point on masking tape with
a pen.
●A = Reference point / rear of front door
●Please check the front of this manual for
information relating specifically to your
vehicle.
7

Fitting Kit EN
K987
Permanent Mount Fitment
●Mark as shown.
●Repeat for all positions.
●Please check the front of this manual for
information relating specifically to your
vehicle.
●Line up the centre hole in the mounting
block with the marked reference points.
8

Fitting Kit EN
K987
●Mark as shown.
●Remove as shown.
●Remove as shown.
9

Fitting Kit EN
K987
●Apply protective tape as shown.
●Cut protective strip as shown.
●Cut protective strip as shown.
●Check fit.
10