Protect 600i Series Instruction Manual

INSTRUCTIONS FOR
INSTALLING 1000 ML
FLUID BAG KIT
PROTECT 600/600i/1100/1100i/2200/2200i
PROTECTGLOBAL.COM

Place the supplied metal plate as shown in the diagram
and push it a little to the left until it clicks into place.
Attach the metal plate to the base plate with a screw
(T20).
2
IMPORTANT:
DO NOT TOUCH!
!
ATTENTION!
Turn o the power supply to the fog
cannon! Allow the unit to cool down
for at least one hour.
1

Connect the uid bag to the cord and place it in the hold-
er. Now thread the heat resistant strip through the two
holes in the metal plate (but do not tighten the hose with
the strip just yet).
3
4
Connect the uid hose to the unit. When you hear a
“click” it is properly in place.

Place the top cover in the corner to the right and screw
it on the opposite side with the supplied screw.
IMPORTANT: The top cover must not trap the uid bag’s
cap and ensure the hose is placed between the two poles
on the battery.
6
Unscrew the cap on the bag and connect/screw the uid
bag’s plastic adapter to the bag. IMPORTANT: Do not
screw too tight or too loose!
5

7
8
Now the strip can nally be tightened around the uid
hose. IMPORTANT: Do not tighten too tight or too loose!
Scan the QR code and watch a video of how to mount
1000 ML kit and liquid bag.

PROTECT A/S
Hasselager Centervej 5 · DK-8260 Viby J · Tel.: [phone]
[email protected] · protectglobal.com
INFO
Visit PROTECTGLOBAL.COM for more information
about security fog and PROTECT A/S.
IMPORTANT INFORMATION ABOUT
THE WARRANTY
If this manual is not completely followed, PROTECT A/S
cannot be held responsible for any errors caused by
the modication of the fog cannon. In addition, the fog
canon’s warranty will be annulled.