PROTOCOL AIR PAPARAZZI AP DRONE with camera User manual
INSTRUCTION MANUAL
PAPARAZZI AP
DRONE with camera
TM
THANK YOU.
Thank you for your purchase of Protocol’s Paparazzi AP
With Camera. You are about to experience the best of what
remote control ight has to oer. We strongly recommend
that you take the time to read this manual thoroughly. It
contains many tips and instructions on how to get the most
out of this aircraft and maintain it for a long life.
As with any aircraft, this is a precision ying machine. Treat
it well and enjoy all the fun it has to oer, ight after ight.
1
23
Battery cover
67
1. Make sure the drone is turned o.
2. Open the battery cover and remove the battery.
3. Connect the USB charging cable to the battery.
4. Plug the charger into a USB port. The USB light will turn o while
charging and will turn on once fully charged.
Charging time: 50 minutes --- Flying time: approximately 5 minutes
NOTE
1. If the Paparazzi AP and the remote do not sync after following the
checklist, reverse steps 1 and 2 of the process. Turn the remote and
the drone o. Then, turn on the remote rst and then the drone.
2. Turn on the controller; if, after 30 seconds, it has not recognized the
drone, turn o the controller to retry synchronization.
3. If the Paparazzi AP is unsteady in ight, it may not have been able
to calibrate horizontally. Power down both drone and remote and
restart pre-ight procedure.
1. Turn on the drone by connecting the battery wire to the drone and place it
on an even surface.
2. Turn on the remote control.
3. Both indicators on the drone and the remote will ash while they are
syncing.
4. Push the throttle up and then down to sync. You will hear two beeps
and the lights will go steady.
Tip: When syncing your drone keep it in a horizontal position for stable ight.
OPERATION: FLYING THE DRONE
89
10 11
12 13
The Paparazzi AP features 3 speed modes. Low speed is at 40%, Medium is
at 70%, and High is at 100%. Choose the speed based on ight experience
and level of comfort.
Press the Speed +/- button to change the speed mode. The remote control
indicator will beep once for low speed, twice for medium, and three times for
high.
Paparazzi
AP does not
respond
Paparazzi AP
will not hover
or strafe
correctly
14 15
1. The memory card comes pre-inserted into the camera.
SHOOTING PHOTOS AND VIDEO
1. Turn on the drone and sync.
2. Photo: Push the Photo button and the camera will take a photo. The lights
on the drone will ash once as it’s taking the picture.
3. Video: Push the Video and the camera will begin to record. The lights will
continuously ash while recording video. Push the Video button again and
the camera will stop recording.
4. Connect the USB transfer cable to the drone and plug it into the USB port
of your computer. If you are using Windows, the USB will come up on
the removable drive. If you are using OS, then the USB will come up as
“Untitled”.
5. Open the drive and then open the Video or Photo folders to access the .AVI
or JPEG les.
6. .AVI movies can be played in several dierent formats including Quicktime,
Windows Media Player, and RealPlayer.
WARNING: Never remove the card from the video camera while the drone is
turned on.
Thank you for your purchase of Protocol’s Paparazzi AP with Camera.
We know that accidents can sometimes happen and that is why we oer
spare parts kits on our website: ProtocolNY.com.
16 17
