PowerVision PowerDolphin User manual

PowerDolphin
V1.0
快速入门指南
CN
Quick Start Guide
EN
クイックスタートガイド
JP

目录 /CONTENTS
快速入门指南

Quick Start Guide

クイックスタートガイド



󾗲󾗹

1
EN
PowerDolphin
PowerDolphin is a water-surface vehicle that can sail autonomously. Equipped with a robotic camera
arm the PowerDolphin can shoot 4k video and take12 MP photos above and below the water surface.
In addition, you can attach the PowerSeeker sonar to the bottom of the PowerDolphin, to locate sh,
check water temps, and render terrains. You can also attach our bait container or attach a shing line
to the payload feature on the back of the PowerDolphin for precise bait drops. The remote controller
and the Vision+ 2 App provide real-time image transmission and many other features.
On/Off button
Radio antenna
Propeller
Payload system
Hook
Fitting pin
Camera electric joint
Camera manual joint
Battery cover
Rubber plug
microSD card slot
Reset button
Micro USB port
Intelligent battery
Fish nder port

2
EN
You can use the remote controller to operate your PowerDolphin wirelessly with a range of up to 2400
ft, and display real-time zero latency high resolution image’s back to your mobile device through the
Vision+ 2 App. In addition, the collapsible mobile device stand folds right into the remote and can
hold any size iOS and android mobile phone.
Remote

3
EN
Mobile device stand
Antenna
Control stick
Mode buttons
Cruise mode (C)
Normal mode (N)
Underwater mode (U)
Lock/Unlock button
Smart return button
Custom button
(Unhook/Bait button by default;
can be customized in the App)
Power button
Charging port (Micro USB)
Photo button
Video button
Image transmission port (USB)
16 Camera joint control thumbwheel
• Underwater mode (U): suitable for low-speed, underwater scenarios like snorkeling.
The maximum speed is restricted; the camera electric joint can be adjusted for many different views.
• Normal mode (N): This mode is for general high-speed fun and water-surface FPV
scenarios.
The maximum speed is 10mph; the camera electric joint in N mode is set to its initial position and
cannot be adjusted into the water.
• Cruise mode (C): Cruise control function. Take off, release the throttle stick and just steer
the PowerDolphin.
The maximum speed is 10mph; the camera electric joint in C mode is set to its initial position and
cannot be adjusted into the water.
[Notes]:To Enter Cruise mode: Hold the throttle stick in a position for 2s then release.
To Exit Cruise mode: Just move the throttle stick again to regain speed control.
16

4
EN
Fish nder
Fishing line connector Charging port Fish luring lamp
Introduction
Installation
[Notes]:When the PowerSeeker is connected to another mobile device, it cannot connect to
PowerDolphin. Make sure the connection to the PowerSeeker of others phones before using with
PowerDolphin.

5
EN
Charging and battery level
Charging
Download the App to watch the video tutorial of PowerDolphin
Please scan the QR code or go to your App store to download Vision+ 2,
and watch the video tutorial in the App.
Fish nder charging portFish nder charging portRemote charging port

6
EN
2. Fish nder
Battery level
1. Remote (LED indicators)
>60% <20%20%-60%

7
EN
3. Intelligent battery
Level
Low High
Prepare PowerDolphin
1. Install the battery and secure it into place.
1. Ensure that the rubber plug is secured into place to guarantee water prong.
2. Make sure that the battery-sealing ring is intact before installing the battery. Damage to the
rubber seal will result to a unusable battery. The rubber seal can be found under the lip of the
battery top.

8
EN
2. Snap the battery cover close.
3. Unfold the antennas, and adjust the camera's manual part to a
proper position.
Ensure that the antennas are vertical before a sailing for the best communication outcome.

9
EN
Prepare the remote
1. Unfold the antennas. 2. Lift the maobile device
stand.
3. Secure the mobile device
into place.


Remote operations
Default operations for control sticks (Also can be
congured different ways in remote settings in the App)
[Note]Ensure that the antennas
are at positions 1 or 2 for the best
communication outcome.
Left control stick Right control stick
Backward
Forward
Turn left Turn right

Lock/Unlock: Press and hold the
button to lock/unlock the motors.
Smart return: Press and hold to
return home, and short press to
cancel return.
Unhook/Bait: Press and hold to
perform bait drop or hook release
feature, and short press to reset
function.
①②
③

10
EN
Sailing preparations
PDO
2. Start the Vision+ 2 App.
1. Press and hold the on/
off button to turn on
PowerDolphin. The blue
side rail lights indicate
power is on.
4. Put the PowerDolphin
into the water, and use the
unlock button on the App to
unlock the device and start
sailing.
3. Follow the instructions to
connect to the Wi-Fi network
of the PowerDolphin or
connect manually.
Use the Control stick calibration function to customize the
size of control sticks on the screen and on your phone.
Mobile device direct connection mode
Tips:
SSID:PDO_VEH_xxx
Password:12345678

11
EN
2. Press and hold the power
button to turn on the remote.
1. Press and hold the on/
off button to turn on the
vehicle. The blue side rail
lights indicate power is on.
4. Put the PowerDolphin into
the water, and press and
hold the lock/unlock button
on the remote to unlock the
device and start sailing.
3. Start the Vision+ 2 App.
Remote mode

12
EN
1. Hang the line on the unhook
device.
3. Operation complete.
2. Perform the unhook operation.
Or
Unhook

13
EN
1. Install the bait drop device.
3. Operation complete.
2. Perform the bait drop operation.
Or
Remove the device.
PUSH
PULL
Bait

15
CN
了解 PowerDolphin
PowerDolphin 是一款可以在水面快速航行并具备自主航行功能的水面机器人。它可以实现水面和水下
1200 万像素的高清拍照以及 4K 视频录制，同时，搭载 PowerSeeker 智能寻鱼器使得它可以进行寻鱼
和地形绘制，结合拖钩机构和打窝器可辅助钓鱼，并通过遥控器、App 终端实现实时图像预览与各项功
能操作。
开关按键
天线
推进器
拖钩 / 打窝舱盖
挂钩
锁紧销
电动云台
相机手动关节
电池盖
胶塞
Micor-SD 卡槽
复位按键
Micro USB 接口
智能电池
寻鱼器舱盖

16
CN
PowerDolphin 遥控器可支持远程无线操控设备，并可通过 App 在移动端高清显示实时图传。同时，折
叠式移动设备支架可稳定夹持移动设备。
了解遥控器

17
CN
移动设备支架
天线
摇杆
模式切换开关
巡航模式（C）
正常模式（N）
水下拍摄模式（U）
加解锁按键
智能返航按键
自定义按键
( 默认脱 钩 / 打窝，可通过 App 设置 )
电源开关
充电接口（Micro USB）
拍照按键
录像按键
图传接口（USB）
16 云台控制拨轮
• 水下拍摄模式：适用低速、水下拍摄场景
最大速度被限制；电动云台可调节。
•正常模式（N）：适用一般高速、娱乐、水面 FPV 场景
最大速度无限制；电动云台处于初始位置，不可调节。
• 巡航模式（C）：基于正常模式增加巡航模式
最大速度无限制；电动云台处于初始位置，不可调节。
【注】
进入巡航：油门杆稳定在同一位置 2s
退出巡航：巡航状态下重新操作油门
16