Protocol Nauticus 6182-3R User manual

NAUTICUS
RC Speedboat
AGES
+
14
Instruction Manual for
Congratulations on purchasing the Protocol RC Speedboat!
CAUTION: Do not allow children to use this speedboat without adult supervision. Not intended
for use by anyone under 14 years of age. Observe all the rules of water safety at all times when
using this speedboat.
OPERATING INSTRUCTIONS
FOR PROTOCOL RC SPEEDBOAT
Please read the instruction manual carefully before operating.
Boat cover
Housing cover
Boat cover
turn switch
Steering
Bar
Tail
Rudder
Propeller
BOAT PARTS (SEE ILLUSTRATION)
Display stand
Charger Battery Pack
Direction knob
Throttle control
trigger
Remote control
flip cover
Power LED
Directional fine
tuning knob
Power switch
Throttle fine
tuning knob
Frequency
LED
SYNCING THE REMOTE CONTROL AND SPEEDBOAT
To properly sync the remote control and speedboat, place the speedboat on the surface of the
water. The speedboat will draw in water through its intakes and its motor will engage. Next, turn
on the remote control. This will light the red light and cause the green light to flash. When the
green light stops flashing, the remote control and the speedboat are synced. The speedboat is
now ready for use.
INSTALLING BATTERIES IN THE SPEEDBOAT (SEE ILLUSTRATION)
1. Open the top cover of the speedboat 2. Place lithium ion batteries in battery
compartment.
3. Connect batteries and JST plug as
shown in diagram above.
4. Replace top cover of speedboat.
WARNING: CHOKING HAZARD! SMALL PARTS. NOT INTENDED
FOR USE BY CHILDREN UNDER 3 YEARS OF AGE.
INSTALLING BATTERIES
Note: Batteries may pose a hazard to children. Check safety notices provided with batteries
before use. Install batteries under adult supervision.
Warning: Dispose of batteries properly.
Cautions:
• Use only batteries of the size and type indicated.
• Do not mix old and new batteries.
• Do not mix battery types – ie; standard, alkaline or rechargeable.
• Do not mix rechargeable batteries of different capacities.
• Remove all batteries from speedboat after each use; drain any water that has accumulated
inside the speedboat. Water can damage the speedboat’s electronic components and
batteries. Store the speedboat with its battery compartment door open to allow the
compartment to dry.
• Use six “AA” for the remote control.
• Use provided lithium ion batteries or the rechargeable for the speedboat.
INSTALLING BATTERIES IN THE REMOTE CONTROL (SEE ILLUSTRATION)
1. Use a screwdriver to loosen the screws on the battery compartment cover.
2.Lift the cover to remove it.
3. Place the six “AA” batteries in the compartment making
sure to properly align the (+ and -) polarity symbols as
marked inside the compartment.
4.Replace the battery compartment cover and tighten the screws to
secure the cover.
Note: When you notice the range of the remote control decreasing
or weakening, replace the batteries. Non-rechargeable batteries
CANNOT be recharged.
USING RECHARGEABLE BATTERY IN THE REMOTE CONTROL (SEE ILLUSTRATION)
1.Remove the rechargeable battery from the speedboat.
2.Charge the battery for approximately 3.5 hours under adult supervision
for 6-7 minutes of run time.
3.Remove battery from charge before reinstalling battery into speedboat.
4. CAUTION: Battery surface may be warm after recharging.
LIMITED WARRANTY
At Protocol, we’re dedicated to bringing you innovative and well-designed products that make living fun and
easy. We stand behind all of our products and warrant this to be free from defects in workmanship and
materials for 30 days from the date of purchase. The warranty does not cover transportation damage,
misuse, accident, or similar events. Specific legal rights pertaining to this warranty may vary by state.
For service claims or questions please consult our website ProtocolNY.com.
DANGER: THIS IS A RACING BOAT AND OPERATES AT HIGH SPEEDS. IT IS NOT A TOY.
Use extreme care not to touch the propeller or allow it to come in contact with body or loose
clothing. The propeller spins very fast and has sharp edges. Contact with the spinning
propeller can cause serious injury. Use care when turning on the power and when placing
the boat into the water or taking it out. Parental supervision is recommended.

INSTALLATION OF SPEEDBOAT BUMPER
Your Protocol RC Speedboat comes with a protective bumper that attaches to the bow. This
can prevent damage should the speedboat run aground or strike any solid object during use.
The bumper simply snaps onto the bow with gentle pressure. Pull to remove. (see illustration)
SAFETY, CARE, AND MAINTENANCE
• DO NOT use near swimmers.
• Avoid using your speedboat in strong winds, currents or large waves.
• DO NOT use outdoors during electrical storms.
• NOT intended for use by anyone under 14 years of age.
• If speedboat travels outside the range of the remote, hold the remote higher to reestablish
contact or move closer to speedboat if safe and possible.
• DO NOT enter water without taking all safety precautions.
• Do not run your speedboat aground. Doing so may damage it.
• Avoid using your speedboat near swimmers, weeds or other water debris.
• Return speedboat to shore any time you observe it slowing down or losing power.
• DO NOT leave speedboat in water when not in use.
• If running in salt water, please clean the speedboat after use.
• Avoid using in extreme temperatures.
• Never drop or throw your speedboat.
• Wipe speedboat with dry towel after use. Do not use chemical cleaners.
• Always keep fingers and toes clear of moving parts.
OPERATING THE SPEEDBOAT
Your Protocol RC Speedboat is nimble and highly responsive. Follow the tips below to increase
your enjoyment:
• Push the trigger on the remote control forward to move the speedboat forward. (see illustration)
• Pull the trigger on the remote control backward to move the speedboat backward.
(see illustration)
• Pull the trigger on the remote control backward and twist the direction knob left to turn the
speedboat to the left. (see illustration)
• Push the trigger on the remote control forward and twist the direction knob right to turn
the speedboat to the right. (see illustration)
• If the speedboat capsizes, push the trigger on the remote control back and forth until the boat
rights itself. (see illustration)
• If your speedboat automatically turns left instead of traveling in a straight line, slowly rotate the
fine tuning knob right to correct. (see illustration)
• If your speedboat automatically turns right instead of traveling in a straight line, slowly rotate
the fine tuning knob left to correct. (see illustration)
Fine tuning right
Fine tuning left
Flipping the speedboat
BETWEEN USES
1. Remove speedboat from water, open battery compartment and remove all batteries. Drain
any water from inside the speedboat. Store speedboat with battery compartment open to
allow it to dry completely. Store speedboat in dry place away from sun and oily chemicals to
protect finish.
2. Remove batteries from remote control between uses.