ProTubeVR PROVOLVER User manual

ProVolver Instructions
Page 1 | 4
PROVOLVER
INSTRUCTIONS
Hello, fellow gamer!
If you are reading this, it means that you got your
hand on a ProVolver. You will increase your
immersion while playing. We will help you set it
up!
The ProVolver allows you to feel the handgun in
your games. You can use it with one hand or with
two hands whith a rifle or sniper.
We invite you to join our Discord community for
any questions or directly contact us through our
support service on our website.
Setting up your ProVolver should take 10 to 20
minutes.
First, make sure you work in a clear area and be
very careful. Some parts can get lost easily.
Thank you for choosing the best Virtual Reality
stock rifle solution. But do not trust us by word, try
it. And most importantly, enjoy your games!
Feel the game!

ProVolver Instructions
Page 2 | 4
PARTS LIST
CONTENT OF THE BOX IF YOU CHOSE WITH FRONT HAND
x1
x1
x1
x2
x1
ProVolver Module
ProVolver Main
cup
Front magnetic
bracket
M4x12 screw
MagCup
BAG N°4
x1
x1
x1
x2
x2
Hex Key 0,4cm
Hex Key 0,25cm
Hex Key clip
(Not useful for this
product)
Wrist strap
Only for Oculus:
Wrist Straps adaptor
Product description:
Power button
Charging slot
Rear cup
ProVolver Module
Front MagCup
Front magnetic
support

ProVolver Instructions
Page 3 | 4
STEP 1: SLOT THE CONTROLLER INTO THE MAIN CUP
Slide the controller into the Cup
if you took for right handed, put the right controller in
if you took for left handed, put the left one in
You need to press the trigger* in order to introduce and
remove the controller in the cup.
*For all controllers except Valve knuckles.
STEP 2: ATTACH THE MAIN CUP TO THE PROVOLVER
Make sure the clamps are loosen (see picture above)
Place once side of the female rail on the male rail.
Then clip the other side of the female rail (it can be a
little tricky at first since the piece is not shaped yet).
Clip the first clamp.
Do not hesitate to use the allen key provided to loosen the screw and adjust the tightness.
Do the same on the other side to lock the module.
Congratulations!!! Your ProVolver is
now ready to use.
If you use your Provolver single handed, you can refer to the
Haptic documentation to connect it to your wireless Headset or PC.
If you took the front magnetic bracket in option to use the ProVolver as a two handed
Weapon, keep following this tutorial.

ProVolver Instructions
Page 4 | 4
STEP 3 : ATTACH MAGNETIC BRACKET AND MAGCUP (FRONT HAND)
For this last step you will need the front magnetic
bracket and both M4x12 screws*.
*The screws are either on the magnet or in the N°4 bag.
You can place the bracket either on position 1 (higher) or
position 2 (lower) as shown above depending on your
appreciation.
Screw it in place.
Put the front MagCup on the Magnetic support.
Loosen the screw using the bigger Allen key to adjust it.
Slot the controller in the MagCup.
Adjust your front hand ingame and tighten the srew back.
Congratulations!!! Your ProVolver is now ready to be paired.
You can now follow the Haptic documentation to connect it to your gear and enjoy the recoil in your favorite shooters!
Position 1
Position 2