PVI Industries TURBOPOWER 500 N 750A-TPL User manual

Product is patented in the U.S., Canada, and Mexico.
PVI INDUSTRIES, LLC
FORT WORTH, TEXAS 76111
PV 6549 11/07 [phone] •www.pvi.com
LOW NOxTURBOPOWER®• PACKAGED WATER HEATER
NICKELSHIELD®NICKEL-PLATED STORAGE TANK
TANK SERIES 750 GALLONS VERTICAL
MODEL
NUMBER
Recovery gph cINPUT
Btu/h
Min. Inlet
Flow Gas
Pressure
" W.C. e
SCAQMD Energy
Model No.
Dimensions (inches) Blower
Motor Shipping Weight
lbs
40° - 120°F 40° - 140°F A B C J dHP Amps
500 N 750A-TPL 500 400 399,000 4.5 4TPL 399 MBtu/h 28 5 3/4 16 1/3 8 2660
cRecoveries based on 83% thermal efficiency. ASHRAE 90.1 compliant for efficiency and standby loss.
d“J” dimension is for the burner housing only – gas train may exceed this dimension.
eStandard gas train.
* The information presented is for natural gas 0.6 S.G.
Dimensions are in inches unless otherwise specified.
For standard and optional equipment, see form #PV6540.
STANDARD GAS PRESSURE REQUIREMENTS: STANDARD ELECTRICAL REQUIREMENTS:
SEE TABLE FOR MINIMUM PRESSURE BY MODEL NUMBER.
MAXIMUM STATIC INLET GAS PRESSURE IS 14" W.C.
FOR GAS PRESSURES OUTSIDE OF THIS RANGE,
CONTACT YOUR PVI REPRESENTATIVE.
CONTROL VOLTAGE: 120V, 1Ø, 60 HZ., 2 AMPS.
MOTOR VOLTAGE: 1/3 HP ARE 120V, 1Ø, 60 HZ.
208V, 230V AND 460V MOTORS ARE AVAILABLE BUT WILL
REQUIRE A SEPARATE 120V/2 amps CONTROL CIRCUIT OR AN
OPTIONAL CONTROL CIRCUIT TRANSFORMER.
VENTING REQUIREMENTS:
-.02" TO -.06" W.C. (NEGATIVE PRESSURE).
TYPE B VENTING.
ENTIRE VENT SYSTEM SHOULD NEVER BE SIZED BASED UPON
THE VENT CONNECTION DIAMETER EXCLUSIVELY. CHECK
NATIONAL FUEL GAS CODE UNDER "FAN ASSISTED."
PVI RESERVES THE RIGHT TO CHANGE THE DESIGN AND SPECIFICATION WITHOUT NOTICE.