PVI Industries TURBOPOWER 250 N 400A-TPL User manual

Product is patented in the U.S., Canada, and Mexico.
PVI INDUSTRIES, LLC
FORT WORTH, TEXAS 76111
PV 6547 02/25/04 [phone] •www.pvi.com
LOW NOxTURBOPOWER®• PACKAGED WATER HEATER
NICKELSHIELD®NICKEL-PLATED STORAGE TANK
TANK SERIES 400 GALLONS VERTICAL
Recovery gph cDimensions (inches) Blower
Motor
MODEL
NUMBER 40° - 120°F 40° - 140°F
INPUT
Btu/h
Min. Inlet
Flow Gas
Pressure
" W.C. e
SCAQMD Energy
Model No. A B C J dHP Amps
Shipping
Weight
lbs
250 N 400A-TPL 250 200 199,000 4.5 2TPL 199 MBtu/h 28 4 1/2 16 1/3 8 1722
375 N 400A-TPL 375 300 300,000 4.5 3TPL 299 MBtu/h 28 4 3/4 16 1/3 8 1730
500 N 400A-TPL 500 400 399,000 4.5 4TPL 399 MBtu/h 28 5 3/4 16 1/3 8 1740
cRecoveries based on 83% thermal efficiency. ASHRAE 90.1 compliant for efficiency and standby loss.
d“J” dimension is for the burner housing only – gas train may exceed this dimension.
eStandard gas train.
* The information presented is for natural gas 0.6 S.G.
Dimensions are in inches unless otherwise specified.
For standard and optional equipment, see form #PV6540.
STANDARD GAS PRESSURE REQUIREMENTS:
SEE TABLE FOR MINIMUM PRESSURE BY MODEL NUMBER.
MAXIMUM STATIC INLET GAS PRESSURE IS 14" W.C.
FOR GAS PRESSURES OUTSIDE OF THIS RANGE,
CONTACT YOUR PVI REPRESENTATIVE.
VENTING REQUIREMENTS:
-.02" TO -.06" W.C. (NEGATIVE PRESSURE).
TYPE B VENTING.
ENTIRE VENT SYSTEM SHOULD NEVER BE SIZED BASED UPON
THE VENT CONNECTION DIAMETER EXCLUSIVELY. CHECK
NATIONAL FUEL GAS CODE UNDER "FAN ASSISTED."
STANDARD ELECTRICAL REQUIREMENTS:
CONTROL VOLTAGE: 120V, 1Ø, 60 HZ., 2 AMPS.
MOTOR VOLTAGE: 1/3 HP ARE 120V, 1Ø, 60 HZ.
208V, 230V AND 460V MOTORS ARE AVAILABLE BUT WILL
REQUIRE A SEPARATE 120V/2 amps CONTROL CIRCUIT OR AN
OPTIONAL CONTROL CIRCUIT TRANSFORMER.
PVI RESERVES THE RIGHT TO CHANGE THE DESIGN AND
SPECIFICATION WITHOUT NOTICE.