
www.PyleUSA.com
5
How To Plug In
Before you install batteries or plug your amp into an outlet, make sure that
all volume knobs or are at zero. The Mini Amp powers ON, once you plug
or install the batteries.
Plug one end of the instrument cable into the jack on the bottom of your
ukulele until it “clicks” into place as far in as it will go. Plug the other end of
the cable into the “input” jack on your amp in the same fashion.
Turn the volume up on the amp as you strum the strings until you reach
the desired volume level.
INPUT
MP3 IN
PHONES
DC 9V
Amplier Setup
1. Turn the VOLUME on the amp all the way down.
2. Install batteries in the amplier. Alternatively, you can connect the
included AC adapter to the jack on the rear panel, then plug the adapter
into an AC outlet.
3. Plug your Ukulele into the INPUT jack at the back of the mini amp.
If you also plan to use a CD or MP3 player, or a microphone, connect
the player to the AUX IN jack or the microphone to the MIC IN jack at the
back of the mini amp.
4. Slowly raise the VOLUME to a desired level.
5. Do not block any ventilation openings.
NOTE:
Be sure to install batteries in the correct orientation.
If the battery level becomes low, noise may be generated.
Depleted batteries must be removed from the amplier immediately.