Pyle Pslerk4 User manual

Electromagnetic

Rat Repellent/Killer

User Manual

PSLERK4

ELECTRONIC RAT KILLER

1. Features & Functions:

1) Delivers high voltage electronic shock to kill rat, nonpoisonous, safe and reliable.

2) Set with safety protection switch, in order to prevent mistake electric shock to person.

3) Use micro-electronic circuit technology for product design, low power consumption, suitable for long life operation.

4) Low battery indication.

2. Application:

This unit widely applies in dining-room, cookroom, bedroom, office, hotel and any places that rats usually appear.

3. Directions for use:

1) Step #1: Using a plastic or wooden knife, insert a small amount of peanut butter (or any food that rats prefer) through a bottom hole on the back

plate.

2) Step #2: Insert 4”C” batteries into battery compartment or use the adapter DC-6V

3) Step #3: Identify location with rat activity look for worn trails or walkways. Place unit on floor against wall, the entrance in-line with the trail; rats

prefer to travel against a wall.

4) Step #4: Press switch to “On” position. Unit will hum, and the green light will flash, then the red light will flash every 5 seconds, indicating that

the unit has been enabled. To prevent incidental shock avoid contact with metal plates. Do not touch the bottom of the machine.

STEP 1 STEP 2 STEP 3 STEP 4

Clean:

STEP 5 STEP 6

4. Note Items for Use:

1) The rat triggers metal plates when rodent enter the unit, and the unit emits high voltage sock immediately, the red light flashes. High voltage

produced time is 4 minutes. Firstly it delivers high voltage last for 1 minute, later impulse electric-shock which imitating rat heartbeat 15HZ for each

time and it continues for 3 minutes, then the high voltage shock stops, the light turns from red to green and flashes once every 5 seconds, here high

voltage shock will not be produced until restarting the unit next time.

2) Every after killing the rat, press switch to “OFF” position (O) and remove case of the unit to clean the chamber, dry it under the sun, then it can be

reinstalled to use. (Use cleaning agent to clean out the smell that the rat remained, or rats may not come again). How to clean it is showed in STEP5 and

STEP 6.

3) In the high-voltage chamber, there are three metal plates, when a mouse or rat enters, it will conduct the charged electricity from one plate to

another and will be killer instantly. To prevent incidental shock avoid contact with metal plates.

4) If red light flashes once every 2 seconds after power on or rat killing, indicating that the batteries should be changed with new to avoid affecting

rat killing function. Turn off power before changing batteries.