Pyle PWMA1216BM User manual

PortablePASpeakerAmplifier
&MicrophoneSystem
Bluetooth Wireless Streaming, Built-in Rechargeable Battery,Accessory Kit
(Includes Handheld Mic, Headset Mic, Lavalier Mic, Belt Pack Transmitter)
PWMA1216BM

www.PyleUSA.comwww.PyleUSA.com
2 3
CAUTION
1. This unit has a speaker inside which can cause magnetic eld. Keep this
unit at least 60cm away from computer or TV.
2. This unit has built-in rechargeable battery. Please recharge the battery
every 2 months if you are not going to use the unit for a long period of
time to prevent battery damage.
3. If the battery is damaged please replace with same specications battery
and dispose the damaged battery environment friendly.
4. Free from high temperature. Don't expose the device to hot equipment.
5. Don't place the device in the environment of humidity and dirts.
6. Place the device in the ventilated environment.
7. Don't pull the power cord while you pull out the plug. Hold the plug
tightly to pull it out.
8. Pull out the AC power if you will not use the device for a long time.
9. Your operation must be subjected to the specied voltage marked
near the AC in jack and complied with this guide.
PARTS DESCRIPTION
AC POWER OPERATION
Plug one end of provided AC cord into the AC input jack on the right side of
the amplier. Then plug the other end of AC cord into AC power outlet. Turn
on the unit using the power/volume switch.
NOTE:
To avoid damaging your unit, make sure AC power is same as that marked
near AC input jack)
DC POWER OPERATION
This unit can be powered also using external 12V DC power.
Connect external 12V DC power to DC input jack on top panel of the
amplier. Observe the correct polarity as following.
23
TREBLE
BASS
ECHO
CHG
REC OUT MIC IN W/MIC VOL POWER
ON
OFF
MP3 VOL
DC 12V
15
14
13
12
11
10
987 6
5
4
3
2
1
16
17
18
19
20
21
22
10. T
1
1. Power ON/OFF switch
2. MP3 volume control
3. Power ON LED indicator
4. RF ON LED indicator
5. External DC input jack
6. Wireless receiver antenna
7. Charge LED indicator
8. Echo level control
9. Bass level control
reble level control
1. Record out jack
12. MIC Input jack
13. Wired/wireless MIC
volume control
14. MP3 display
15. MP3 mode
16. MP3 previous/volume-
17. MP3 next/volume+
18. MP3 play/pause
19. USB port
20. SD/MMC card slot
21. Speaker
22. AC input jack
23. Battery compartment

www.PyleUSA.comwww.PyleUSA.com
4 5
RECHARGEABLE BATTERY OPERATION
This unit can be powered internally using the built-in rechargeable battery.
When AC power is connected, if battery charging indicator lights red, the
rechargeable battery is not fully charged and will be allowed to charge while
the unit is powered by the AC power.
Note:
Turning o the unit power switch will allow the battery to recharge more
quickly.
If the battery charging indicator lights green, the battery is fully charged and
ready to power the unit alone. Shut o the power switch and disconnect the
AC power. Turn the unit back on and the rechargeable battery will power the
unit alone.
CONNECTION
The REC OUT socket can be connected to a recording device or to the input
jack of a power amplier to further amplify and enlarge the audio power.
The MIC IN socket can be connected to wired dynamic MIC.
Keep MIC head away from the speaker of main unit to avoid feedback.
BLUETOOTH/MP3 OPERATION
1. Insert ash drive into USB port or Micro SD Memory Card into Micro SD
Memory Card Slot, system will play the music in ash drive or Micro SD
Memory Card automatically. If both ash drive and Micro SD Memory Card
are inserted, system will play the music in ash drive. To play music in
Micro SD Memory Card press MODE button to switch to SD mode.
2. To play music from your mobile phone etc via bluetooth, press MODE
button to switch to BT mode. Turn on bluetooth function of your mobile
phone and search for Pyle Audio and connect. Then you can play your
music in mobile phone.
ATTENTION:
1. If feedback (howling sound) occurs, try rst turning down the treble
control. If feedback still is present, try turning down the volume or
repositioning this unit with respect to the wired or wireless microphone
being used.
2. Extend the antenna fully whenever using the wireless microphone to
ensure optimum performance and maximum range.
OPERATION OF WIRELESS MICROPHONE
1. Open battery cover and install 2PCS AA batteries into battery
compartment with correct polarity. Then close the battery cover.
2. Slide power switch to “ON” position to turn on the microphone.
Power indicator will ash once and then go o. This indicates correct
operation.
3. The RF indicator on the amplier should now be lit.
4. Adjust the wireless MIC volume control of the amplier to a comfortable
listening level as desired.
5. Slide power switch to center “MUTE” position to mute the sound.
6. During operation if power indicator lights red, this indicates the battery is
Iow. Please replace new battery.
7. If the microphone is not going to be used for any length of time, slide
power switch to OFF position and remove the battery.
BELT PACK TRANSMITTER OPERATION
Battery Cover/Compartment
Power Switch
Power/Low Battery Indicator
Grille(capsule inside)
5
4
123
6
7
1. Power On/Off/Mute switch
3. Power/low battery Indicator
4. Gain adjustment
5. Battery compartment/cover
6. Lapel MIC
7. Headset MIC
2. MIC input socket

www.PyleUSA.comwww.PyleUSA.com
6 7
1. Open battery cover and install 2PCS AA batteries into battery
compartment with correct polarity. And then close the cover.
2. Plug in either the clip-on or the headset microphone.
3. To use the clip-on MIC, attach it at chest level. Do not place too close to
the mouth - a distance of about six inches usually works best. To use the
headset MIC, place it on the head and adjust the MIC boom so that the
MIC is about one inch to the side of the front of the mouth.
Note: The clip-on or headset MIC wire is also the transmitting antenna.
Rolling up or shortening the wire may reduce the eective operating range.
Extend the wire fully during use and keep it as straight as possible.
4. Turn on the transmitter by sliding the power switch to ON position.
Power indicator will give a single quick ash, indicating usable battery
strength. In the case of a dead or low battery, the power indicator either
will not go on at all or will stay on continuously, indicating that the battery
should be replaced with a fresh one.
5. The RF indicator on the amplier should now be lit.
6. Adjust the volume control of body pack and/or volume control of the
amplier to a comfortable listening level as desired.
7. If the transmitter is not going to be used for any length of time, push
power switch to OFF position and remove the battery.
PWMA1216BM
Portable PA Speaker Amplier & Microphone System
Bluetooth Wireless Streaming, Built-in Rechargeable Battery, Accessory Kit
(Includes Handheld Mic, Headset Mic, Lavalier Mic, Belt Pack Transmitter)
Features:
• Versatile Public Address Microphone & Speaker
• Bluetooth Wireless Music Streaming Ability
• USB Flash & SD Memory Card Readers
• MP3 Digital Audio File Compatibility
• Built-in Rechargeable Battery, 10+ Hour Operation
• 1/4'' Microphone Input Jack
• Audio (3.5mm) Output, Connect External Speakers
• Full Range Stereo Sound Reproduction
• Includes Wireless VHF Handheld Microphone
• Echo, Bass, Treble Audio Conguration Controls
• Includes Power Cable & AA Batteries
• Ability to be Powered by External Wall Power Adapter
• Perfect for Karaoke, Crowd Control, House Parties
• Lightweight, Portable & Powerful
• Impressive Bass Response
• Convenient Carry Handle
Bluetooth Connectivity:
• Wireless Music Streaming Audio
• Works with All of Your Favorite Devices
(Smartphone, Tablet, Computer, Laptop, MP3 Player, etc.)
• Bluetooth Version: 3.0
• Bluetooth Network Name: Pyle Audio
• Bluetooth Wireless Range: 30' ft.
What's in the Box:
• PA Speaker
• Wireless Handheld Microphone
• Beltpack Transmitter
• Headset Microphone
• Lavalier Clip-On Microphone
• (4) x 'AA' Batteries
• Wall Power Cable
• Cigarette Lighter / Vehicle Outlet Power Cable
• Travel / Storage Bag
Technical Specs:
• Battery Operated Mic/Beltpack: Require (2) x 'AA' Batteries (Each)
• MAX Power Output: 60 Watt
• Speaker Impedance: 4 Ohm
• Frequency Response: 25Hz-15kHz
• Maximum USB/SD Flash Memory Support: 32GB
• Digital Audio File Support: MP3
• Power: DC 12V, AC 120V
• Dimensions (L x W x H): 7.2'' x 4.3'' x 11.6''