quadient WTS MC67 Manual

MC67
SETUP
Setting up and connecting the MC67 handheld devices to receive and deliver
requires several steps. These steps are setting the date and time, connecting
to a Wi-Fi network, and configuring the handheld with site credentials.
Setting up the Date and Time
1. From the home screen,
pull down from the top
to reveal the menu.
2. The three bars at the
top is the menu icon.
Pressing this icon will
open the menu.
3. Scroll down and select
Date & Time.
4. Uncheck both
‘Automatic date & time’
and ‘Automatic time
zone’ which will allow
the setting of date and
time. Once these are
set, re-check the
previous check boxes.
5. Press the ‘Home’
button. Pull down the
screen from the top to
reveal the menu.
6. Verify the settings were
saved by the date and
time displayed at the top
of the menu.

Connecting to a Wi-Fi Network
1. From the home screen,
pull down from the top
to reveal the menu.
2. The three bars at the
top is the menu icon.
Pressing this icon will
open the menu.
3. Make sure Wi-Fi is turned
on and press the word
‘Wi-Fi’.
4. Select the proper Wi-Fi
which will bring up the
login credentials page.
5. Enter the credentials
and you should now
see the word
‘Connected’ under the
proper Wi-Fi network.

Configuring the Handheld with Site Credentials
1. Locate the WTS(-P) app
from the main screen or
the apps menu.
2. Begin by pressing
‘Continue’ to register
the device.
3. Leave the settings to
‘Auto’. Enter the install
code and URL (leave as is
unless otherwise
instructed).
4. The install code is
located on the install
sheet under Admin –
Devices –Print Install
Sheet.
5. If all is correct you will
see the registration was
accepted. Select
‘Continue’.
6. Enter your user name and
password and select
‘Login’.

7. You are successful if
you see the ‘kite’
screen.
8. The MC67 is configured
and ready for use.