Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC 29445
Customer Service
Phone 631.273.2700
Fax 631.231.7102
www.quoizel.com
Pleasegoto forproductcleaningtips.Gotothe selection.www.quoizel.com Care + Maintenance
ToolsRequired:Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,
safetyglasses.
EstimatedAssemblyTime:30-45 minutes
Preparation:Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagrams
belowtobesureallpartsarepresent.Ifanypartsaremissingordamaged,donotattempttoassemble,install,or
operatethefixture.Contactcustomerserviceforreplacementparts.
Warnings and Cautions
1of2
Assembly Instruction Sheet #IS-Q1770F
For Styles Q1770F,Q1771FPN,Q1772FB
LightSource: (3)A19Medium Base 60W Bulb Maximum,Alternatebulb(3)13WCFL
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,.
..
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2015 QuoizelInc. July2015
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering July result.
Package Contents
A
B
C
D
E
Loop
x1
Shade
x1
Socket
Assembly
x3
Center
Column
x1
Rod with
Connector
x1
STEP 1 Install Rods, Center Column
and Socket Assembly
-
A. Thread the Socket Assembly (C), the
Center Column (D), the Rod with
Connector (E), the Rod (F) and the Base
(G) together as shown. Hand tighten until
snug.
B.PullthecordfromtheBase(G)asyou
assemble the parts together to remove
the excess cord between parts.
Figure 1
C
D
STEP 2 Install Shade-
A. Attach the Shade (B) over the nipple
on the top center of the Socket
Assembly (C) and secure with the
Loop(A). Hand tighten until snug.
Figure 2
B
C
A
F
Rod
x1
G
Base
x1
E
F
Cord
STEP 3 Install Bulb-
A. This fixture uses standard bulb with
medium base . Maximum 60 watts.
B. Insert bulb and screw snugly into
place.
Your fixture is now assembled and
ready to use. Enjoy!
Figure 3
Bulb
G
