Room Selecting the virtual room to which the device is
assigned
Delay When Entering, sec Setting the delay time when entering
Delay When Leaving, sec Setting the delay time on exit
Delays in night mode Delay turned on when using night mode
Arm in Night Mode If active, the detector will switch to the armed
mode when using the night mode
Primary Detector If active, DoorProtect primarily reacts to
opening/closing
External Сontact Enabled If active, the detector registers external detector
alarms
Always active If active, the detector always registers
opening/closing
Activate the siren if the door or window is open If active, and are
activated when the opening detected
Activate the siren if an external contact opened If active, HomeSiren and StreetSiren are
activated during an external detector alarm
Jeweller Signal Strength Test Switches the detector to the signal strength test
mode
Detection Zone Test Switches the detector to the detection area test
Attenuation Test
Switches the detector to the signal attenuation
test mode (available for detectors with
rmware version 3.50 and later)
User Guide Opens the detector User Guide
Unpair Device Disconnects the detector from the hub and
deletes its settings
Indication
Event Indication Note
Switching on the detector Lights up green for about one
second
Detector connecting to the
, and Lights up for a few seconds
HomeSiren StreetSiren
hub ocBridge Plus
uartBridge
