RAB Design EVP5 Pro User manual

PEDESTAL –INSTALLATION STEPS
•Remove the top cover and base of the pedestal.
(Not fastened to pedestal for quick disassembly)

PEDESTAL –INSTALLATION STEPS
•Remove the required rubber plugs and
attach screws and washers
(hardware by others) for mounting
the charger.

PEDESTAL –INSTALLATION STEPS
•Attach an appropriate strain relief and secure it
from inside the pedestal (Tool access through top).

PEDESTAL –INSTALLATION STEPS
•Hook the charger to the pedestal using the top mounting screw and secure it in place using the
bottom screw.
Bottom Mounting Screw
Top Mounting Screw

PEDESTAL –INSTALLATION STEPS
•Use a cable of atleast 5’length and connect one end of the cable to the charger terminals
and feed the other end through the strain relief into the pedestal.

PEDESTAL –INSTALLATION STEPS
•Attach the pedestal mounting plate on the ground with provided
anchor bolts.
•Pull the power line through the bottom of the pedestal
and connect it to the cables coming from the ground.

PEDESTAL –INSTALLATION STEPS
•Slide the Pedestal over the base and fasten using 4 screws provided.
•Attach the top cover using the 8 screws provided

PEDESTAL –INSTALLATION STEPS
•Attach the charger cover using the
Charger hardware.