Racelogic PerformanceBox User manual

Quick Start Guide
Installation
For best satellite reception, ensure your PerformanceBox
is fixed low down in the centre of the windscreen. The
first time the unit is used, it will need to be left for 10-15
minutes to fully acquire satellites. After this, it will usually
take 1-2 minutes to acquire satellites.
Lap Timing - Setting a
Start/Finish line
Ensure the unit is in Lap
Timing mode. Press or
button while driving over
the point you wish to define as
your start/finish line.
Either button
sets lap start/
finish line
Register your PerformanceBox to activate all functions:
www.vboxmotorsport.co.uk/register
Performance Tests
Ensure the unit is in Performance Mode. In this
mode, you can select a number of user-configurable
tests, including 0-60, 0-100, 0-100-0, ¼ mile etc.
Before starting an acceleration test, ensure the
vehicle is absolutely stationary.
Once a test has been performed and the vehicle has
stopped, you can immediately start another test. You
do not need to press any buttons between tests of the
same type. For best results, perform tests away from
buildings and trees.
Press or
to scroll between
tests
On the SD card:
Performance Tools
software
Circuit Tools software
User manual

Predictive Lap Timing
PerformanceBox Predictive Lap Timing mode
compares your current lap with your best so
far, in real time. Enter this mode from the lap
timing screen.
Data Logging
PerformanceBox continually logs data to an
SD card (if inserted) when the vehicle is
moving. Data can then be analysed using the
Circuit Tools software.
Analyse your data using Circuit Tools software
Interested in recording RPM or other vehicle data too? Try the
Micro Input Module with four analogue inputs.
www.vboxmotorsport.co.uk/performancebox
To ensure trouble-free data capture, RACELOGIC recommends using a quality SD/SDHC
card such as Lexar, SanDisk or Kingston.