RadioPopper L-358 User manual

Sekonic Module
Quick Start Guide
Thank you for purchasing the RadioPopper
compatible transmitter module. This module may
be installed into the following Sekonic brand light
meters: L-358, L-758D, L-758DR, L-758Cine, C-500R
Installation Instructions
1) Remove the battery cover from the back side of
the Sekonic light meter. Refer to the picture on the
reverse side of this guide.
2) If your Sekonic light meter already contains a radio
module in the opening (it will look like a small plastic
box set inside the square space above the battery),
carefully remove the existing module. If a module is
not already present, you may see a small cover over
the connecting pins inside the opening. Remove the
cover from the connecting pins if present.
3) Align the connecting pins inside the light meter
with the connector on the back side of the Radio-
Popper module. Carefully press the RadioPopper
module onto the connecting pins inside the light
meter. The RadioPopper module may be removed if
necessary by pulling on the green ribbon.
4) Follow the instructions provided with your
Sekonic light meter to enable Wireless Flash Radio
Triggering Mode. Select a radio channel between
1 and 16. This radio channel will correspond to the
RadioPopper radio channels 1 to 16. The light meter
will automatically set the correct radio channel on
the RadioPopper module.
5) Conrm proper operation of the RadioPopper
module by observing the green light in the lower
right corner of the module. It will blink periodically
to indicate proper operation and that your light
meter is congured correctly. Each time you trigger
your meter to take a light reading, this green light
will strobe momentarily as your wireless lights are
activated.
6) Replace the battery cover on your Sekonic light
meter. You’re all done. Happy metering!

FCC STATEMENT
This equipment has been tested and found to comply with the
limits for a class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician for
help.
Operation with non-approved equipment is likely to result in
interference to radio and TV reception. The user is cautioned that
changes and modications made to the equipment without the
approval of manufacturer could void the user’s authority to operate
this equipment.
Important Note: To comply with FCC RF exposure compliance
requirements, the following antenna installation and device
operating congurations must be satised - This device and its
antenna(s) must not be co-located or operating in conjunction
with any other antenna or transmitter.
When complete, the RadioPopper module should
look like this:
Support
Need help? We’re happy to oer support.
Online Support: radiopopper.com/support
Email: suppor[email protected]
Phone: [phone]
Specications
Supply Voltage:
3.3 Volts DC
Radio Frequency:
902-928 MHz, ISM Band
Leap Devices LLC, DBA RadioPopper is not aliated with,
maintained by, or in any way ocially associated with Sekonic
Corporation. Sekonic is a registered trademark of Sekonic
Corporation.
FCC ID: V4TSKT1
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) this device must accept any interference received,
including interference that may cause undesired operation.