Rainfresh P2S User manual

ASSEMBLY AND OPERATING INSTRUCTIONS – SIPHON WATER FILTER
MODEL P2S
Please save for future reference
This Rainfresh siphon water filter is designed to provide microbiologically safe drinking water. The unit includes a
ceramic filter cartridge that traps and kills harmful bacteria >99.99999% (E. coli, Coliforms, Faecal Coliforms), traps
protozoan cysts (Giardia, Cryptosporidium) and filters particulates as small as 0.3 microns (99.9%).
Note:
1. Contaminants reduced by this filter are not necessarily in your water.
2. For cold water use only
3. Individuals requiring water of specific microbiological purity should follow the advice of their doctor or local
health unit.
4. Do not subject this unit to freezing temperatures or it will crack.
5. Do not boil the cartridges to disinfect. They are self disinfecting.
NOTE: Three P2S units are packed together in one box. Each P2S system comprises of the following
HOW TO USE THE UNIT
NOTE: The ceramic cartridge is fragile, please handle carefully.
1. Remove Pails and Lids from box. Place wrapped siphon cartridge aside.
8. Place this filled pail 3-5 feet above the ground. Place second Pail on ground.
6.
The siphon unit pre-
assembled including
ceramic cartridge
One Scrubbing pad
Part # : 811-0
One Filter
cartridge gauge
Part # : 703-4
Two Pails with lids
and handles
2. Attach Handles
to Pails 3. Tear the pull tab on
the lid and tear away
the lid seal
4. Lift tabs on Hole Caps
and unthread Caps from
both Lids
5. Fill one Pail with water to 1” from top.
Unwrap Siphon Cartridge and place in Pail
and let soak for 30 minutes or until cartridge
is fully wetted and sinks to bottom.
6. Pass siphon tube through bottom of hole in
one lid and place lid on pail.
7. Attach the
other open end
of tube from the
ceramic
cartridge to the
ball valve
9. With Tube Valve open, suck on end of Tube to draw water into full length of tube. Bend down with tube still in
mouth and place tube end in second pail. Leave Tube Valve exposed.
ON OFF
One metal chain

10. When bottom Pail is full, close Tube Valve and refill top
bucket. Empty filtered water of bottom pail, replace tube into
Lid hole and open Tube valve to start flow again from top
bucket. Note: If siphon is lost – repeat step 7.
Note: Make sure that the water in the tank always stays
above the ceramic cartridge; otherwise water flow will stop. If
this happens, fill the tank again and repeat step 7.
CARTRIDGE CLEANING
Note: Do not use soap or detergents when cleaning. Use only water.
When the water flow reduces, the cartridge requires cleaning. Use
cleaning pad (811-0) to scrub cartridge gently and evenly all over. You can
clean the cartridge under running water or in a bucket full of water.
Cartridge may be cleaned many times until cartridge gauge 703-4 can be
passed over width of the ceramic. When gauge can be passed over the
width of the cartridge, it is time to replace it.
The use of
rubber gloves
(i.e. dishwashing gloves) or other sensible hygiene
precautions is recommended during handling, cleaning
or disposal of the dirty cartridge.
CARTRIDGE LIFE:
(Approximate): 6 to 12 Months. Cartridge life is directly
related to your water conditions, volume of water
filtered and frequency of cleaning. Frequent cleaning
ensures best efficiency.
Max cartridge flow rate: 1 US gal/hr (3.8 Litres per hour) when separated by 3 feet (76 cm) head.
ENVIROGARD PRODUCTS LIMITED
446 Major Mackenzie Dr. E., Unit 6, Richmond Hill, ON Canada L4C 1J2
Tel: 001 – [phone] ; Fax: [phone]
www.rainfresh.ca
©COPYRIGHT * ENVIROGARD PRODUCTS LIMITED 2008 * ALL RIGHTS RESERVED P2S Instructions E Oct 2008
If Cartridge gauge does not
pass over the cartridge
Cartridge can be reused
If Cartridge gauge passes
over the cartridge, Cartridge
should be replaced
11. Pass the metal chain through
the two lid hole covers, the
cartridge gauge and the cleaning
pad and lock the chain around
the lid of one of the pails.