RAINSHOWER REFRESH Manual

Thank you for your purchase of Rainshower’s Refresh Shower Filter. The
Refresh is tested by WQA according to NSF/ANSI Standard 177 to treat the
chlorine in your shower for up to 30,000 gallons of water.
NOTE: This product contains non-toxic granular lter media,
produced within the regulations of The Safe Drinking Water Act (PL
99-339, June 19, 1986).
Some of the smallest grains of ltration media may shake out during
shipping and handling. This is normal, and does not mean that the lter
is defective or damaged in any way. When the lter is wet, the grains are
held together and are not ushed out by the water ow during operation.
The operational life of this product may vary depending on the quality of
the source water and proper maintenance.
Areas with high levels of particulate matter in the source water or excessive
scale buildup in the pipes may result in a reduction in water ow.
This product and installation shall comply with state and local regulations,
and is not intended for use as a drinking water treatment unit.
INSTRUCTION GUIDE
Shower Filter
REFRESH
F543-RS / 0421
WARRANTY
The manufacturer warrants the product to be free from defects in
materials and workmanship when installed, operated, and maintained
in the manner instructed in this document. Filter housing is warranted
for a period of one year from the date of purchase. The lter cartridge
is warranted for a period of 90 days from the date of purchase. The
manufacturer will repair or replace any shower lter that fails to perform
due to faulty materials or workmanship. Items not covered under the
warranty include: damage due to misuse, improper maintenance,
improper installation, excessive water pressure or temperature, freezing,
or general misapplication of the product’s use and purpose. There are
no warranties, expressed or implied, other than those stated herein.
Rainshower is not liable in any way for any damages arising from the
misuse or misapplication of this product. To make claims under this
warranty, please contact your Rainshower dealer.
The NEWCEN-RS is tested and certied by
Water Quality Association according to
NSF/ANSI Standard 177 for the reduction
of free available chlorine. While testing
was performed under standard laboratory
conditions, actual performance may vary.
7251 Cathedral Rock Dr.,
Las Vegas, NV 89128
702.483.4410
www.rainshower.com
For shipping and orders: [e-mail] • For new dealer
inquiries, product questions, and general information: marketing@
rainshower.com • For all other inquiries: [e-mail]

SPECIFICATIONS
SKU
Approximate Filter Capacity
Approximate Flow Rate
Housing Composition
Housing Dimensions
Product Weight
Filter Media
Working Pressure Range
Operating Temperature Range
Chlorine Reduction
FEATURES
• The Refresh shower lter is designed to provide long-lasting
performance for a variety of water conditions.
b. For a showerhead with additional handheld showerhead:Attach
the shower lter before the showerhead selector valve.
6. ttach the shower lter by threading it onto the shower arm and
rotating clockwise by hand. HAND TIGHTEN ONLY. Do not overtighten.
7. Reconnect the showerhead by rotating it clockwise on the outlet
connector (male thread) of the shower lter. HAND TIGHTEN ONLY. Do
not overtighten.
8. Turn on the shower and allow water to run through the lter for 30 to
60 seconds before the rst use.
LIMITATIONS
• This product is designed for use on potable systems only.
• This product effectively reduces free chlorine only.
• This product does not introduce anything harmful to the water.
• This product is not intended for use as a drinking water lter.
• Do not allow this product to freeze.
• Do not use any type of sequestering agent (polyphosphates) ahead of
the lter.
• Product effectiveness may be reduced when used with water systems
containing high levels of iron or with systems that use chemicals such
as polyphosphates.
• Special crystalline quartz technology acts upon the water to create a
softer feel and a more energizing experience.
• When used with an effective ow-reduction showerhead for optimal
water delivery, this product can save water and energy costs.
INSTALLATION
1. Locate the red plastic plugs on each end of the Refresh and remove
the plugs.
2. Remove the existing showerhead by rotating it counter-clockwise to
unthread from the shower arm pipe.
3. If you use a manual shutoff valve with your shower arm, make sure
that the shutoff valve is attached to the shower arm BEFORE the
shower lter connection.
4. If your shower arm has an integral ball joint:
a. Replace the xture with a standard 1/2” shower arm (available
at most hardware stores), OR
b. Use an adapter (available at most hardware or plumbing
supply stores) to connect the shower lter.
5. If your shower uses a handheld showerhead:
a. For a standalone handheld showerhead:
i. Attach the shower lter before the showerhead mount, or
ii. Attach the shower lter between the showerhead mount and
the showerhead hose.
NEWCEN-RS
30,000 gallons
2.0 gpm
ABS Plastic
4” x 3”
17.6 oz
18 oz. KDF 55,
Sediment Prelter,
Virgin Crystal Quartz
30 psi (2.1 kg/cm2)
to 100 psi (7.0 kg/cm2)
40º F (5º C) to 120º F (49º C)
90% or more