Rane SC User manual

A
B
RMT 1 & 2RMT 1 & 2
1 2 1 2
ZONE 1 ZONE 2
PAGING
ZONE ASSIGN
LEVEL
L1 P
L2 L3
4k630 1.6k40 100 250 10k
CP 64S
COMMERCIAL
PROCESSOR
ACTIVEACTIVE
PAGE 2PAGE 1 LINE 1 LINE 2 LINE 3 PRIORITY
ONOFF
SIG OL
DUCKER
DEPTH
PROGRAM
SELECT
LEVEL
L1 P
L2 L3
ONOFF
SIG OL
DUCKER
DEPTH
PROGRAM
SELECT
LEVEL
PROGRAM INPUT LEVELS ZONE 1 ZONE 2 ZONE 2
4k630 1.6k40 100 250 10k
ZONE 1
POWER
12
•
6
•
•
•
6
12
0
+
100
64
28
100
64
28
100
64
28
100
64
28
100
64
28
100
64
28
100
64
28
100
64
28
RMT RMT
RMT RMT
Security Options
Installation Guide
SC
SECURITY COVERS
19” Security Covers
1. Once you’ve rack mounted the 19" unit, remove the upper-left
and lower-right rack mounting screws (A & B above).
2. Place the security cover over the unit as shown, and reinstall
the rack-mounting screws.
Hole Plugs
Some Rane products are equipped with removable knobs that
can be replaced with hole plugs – thus securing individual
controls. To replace a knob with hole plug, remove the knob by
pulling it off of the shaft. Place the hole plug over the hole and
push it into place.
EQ-Only Security Covers
(Applicable to CP 52S, CP 64S and MLM 103)
e SCP1S and SCP2S security covers only conceal the EQ
sections of the CP 52S and CP 64S respectively. Hole plugs are
also included with the SCP1S and SCP2S for other controls.
e MLM 103 security cover is included with the main unit.
To install, remove the two screws on either side of the EQ
sliders (as shown above). Place the cover over the sliders and
replace the two screws.
Note: e EQ-only security covers can be concurrently used
with 19" security covers.
All features & specifications subject to change without notice. 09190
©Rane Corporation 10802 47th Ave. W., Mukilteo WA 98275-5098 USA TEL [phone] FAX [phone] WEB www.rane.com
19” Security Covers
EQ-Only Security Covers
Hole Plugs