55M3500MNE rev. E
Telescopic cranes with derrick pressure sensors Calibration Manual i3500
2
Contents
1.0 GENERAL DESCRIPTION................................................................................4
1.1 Introduction......................................................................................................4
1.2 Personnel qualification and scope of this manual .......................................4
1.3 Brief description of the I3500 System............................................................4
2.0 THE I3500 SYSTEM..........................................................................................5
2.1 Troubleshooting ..............................................................................................5
2.1.1 Diagnostic Menu...............................................................................5
2.1.2 Error Messages and the use of the “?” ........................................10
2.2 Configuration and calibration.......................................................................16
2.2.1 System options...............................................................................16
2.2.2 Selecting units of measure for calibration: ("- calib. unit:
imperial")........................................................................................................18
2.2.3 Calibration data: ("-calibration data ")..........................................18
2.2.4 Entering fixed data values: ("- dimensions") ...............................20
2.2.5 Relays configuration: ("- relays configuration")..........................26
2.2.4 Digital inputs configuration: ("- dig. inputs config.") ..................27
2.2.7 Angle Calibration............................................................................28
2.2.8 Length Sensor Calibration.............................................................28
2.2.9 Pressure sensor calibration ..........................................................29
2.2.10 Multi-point no-load calibration: ("-no load calibration") .............31
3.0 CANBUS INTERFACES BOARD ...................................................................44
3.1 Angle/length and ATB sensor interface board............................................44
3.1.1 Errors detection..............................................................................44
3.1.2 Basic accelerometer’s calibration:................................................45
3.1.3 ATB ..................................................................................................45
3.2 Relay and digital input interface board:.......................................................45
3.3 Rotation sensor interface board...................................................................46
3.3.1 Relative Encoder...................................................................................46
3.3.2 Absolute Encoder.................................................................................46
3.4 Pressure transducer interface board:..........................................................46
3.5 Sensor voltages.............................................................................................46
Dimensions Data Sheets .........................................................................................47
