Raymarine ST40 User manual

Distributed by
Any reference to Raytheon or
RTN in this manual should be
interpreted as Raymarine.
The names Raytheon and RTN
are owned by the
Raytheon Company.

Adjusting display backlighting/contrast
Normal operation
ST40 Compass Instrument - quick reference guide
orTo exit adjust mode press or wait for 5 second timeout
LEVEL 1 LEVEL 1 OFF LEVEL 2LEVEL 3LEVEL 2
To enter adjust mode, press for 1 second to adjust BACKLIGHTING and a further 1 second to adjust CONTRAST
SWITCH ON
Compass
heading
3 seconds
Set
alarm
level
Alarm on/off
Times out to the
Compass heading
screen after
5 seconds.
Off course
alarm
values
Locked
heading
Auto locked
heading
Course computer
sets auto lock
Course computer
sets auto lock
+
-
Momentary
With Set alarm level screen displayed,
to save the alarm level and return to
normal operation.
and keys simultaneously
press the
86050_2.p65 18/04/01, 16:551

Calibration
ST40 Compass Instrument - quick reference guide
Document number: 86050_2 (to be used with handbook: 81161_2)
Date: 1 May 2001
USER
CALIBRATION
for 2 seconds
Hold down
and
INTERMEDIATE
CALIBRATION
Software
version
Hold down
and
for 4 seconds
M
T
Instrument
status
User
cal
Set compass
heading
response
Set
variation
Linearise
transducer
Deviation
2 turns
minimum
Set
True/
Magnetic
Set
heading
alignment
Linearisation
successful
Master Repeater
+
-
+
-
Bypass
linearisation
To leave any calibration routine and
return to normal operation,
for approximately 2 seconds
andhold down
If there is no key activity with either
the User cal or Software version
screen displayed, calibration will time
out to normal operation after 5 seconds
+
-
86050_2.p65 18/04/01, 16:552