Raypak MVB WHP-2004 User manual

Catalog No.: 6000.29B Effective: 7-15-08 Replaces: 1-1-08
Job:
Engineer:
Contractor:
Prepared By: Date:
Model: Indoor/Outdoor:
85% Thermal Efficiency
100% Factory Fire Tested
Minimum Acceptable Inlet Water Temperature: 105°F
Full Safety Diagnostics with History
Footprint: Less Than 5-1/2 ft2
Limited Twenty-Year Thermal Shock Warranty
Limited Five-Year Heat Exchanger Warranty
On/Off Firing
Soft-Start Modulating Controller with LCD Display
Status Display Lights
Heat Exchanger
Bronze Headers
ASME HLW Stamped
160 PSIG Working Pressure
National Board Approved
Cupro Nickel Fin Tubing
ASME Powder-Coated Tube Sheet
Silicone High Temp O-Rings
ASME Pressure Relief Valve,
125 PSIG
Temperature and Pressure Gauge,
Shipped Loose
Stainless Steel Evaporator Plate
Bronze Pump (See table on pg. 2)
Drain Valves (2)
Air Vent
Control
120V, 60Hz, 1Ø, Power Supply
120/24V 60Hz Transformer
Ignition Module
3-Try – Standard
Single-Try – Option C-6
Hot Surface Ignition (HSI)
Remote Flame Sensor
High Limit, Auto Reset, Adj., 140°F
High Limit, Manual Reset, Fixed
Models 504-1504: 175°F
Models 2004: 200ºF
On/Off Power Switch
Flow Switch, Mtd
Blocked Vent Pressure Switch
Combustion Air Proving Switch
Pump Switch
Pump Time Delay
Diagnostics Panel
Control (cont.)
On/Off Digital Poolstat, 106°F Max
Water Temperature Sensors (3) with
Immersion Well
Burner
Ultra-Low NOx: Less than 20 PPM
Gas Train
Fuel
Natural Gas
Propane
Zero Governor Regulator
Dual-Seat Combination Valve
On/Off Firing with Soft-Start
Construction
Indoor/Outdoor Construction
Enclosed Front Controls
PolyTuf Powder Coat Finish
Rear Connections (Water, Electrical,
Gas, Vent, Combustion Air)
Design Certification
Models 504-1504: ANSI Z21.56/
CSA 4.7
Model 2004: ANSI Z21.10.3/CSA 4.3
Venting
Vent Termination Cap
Outdoor – Option D-11
Indoor, Horizontal – Option D-15
Indoor, Vertical (by others)
Combustion Air
In-Line Filter Kit – Option D-17
Air Intake Elbow – Option D-16
Extractor – Optional
By others
Not required
Temperature Controllers
B-26 TempTracker Digital Controller,
Up to 2 Heaters
B-21 TempTracker Digital Controller,
Up to 4 Heaters
Y-241 Electronic Sequencer,
Up to 4 Heaters
Y-281 Electronic Sequencer,
Up to 8 Heaters
Options
F-10 Low Water Cut-Off, Remote
Probe
P- Cold Water Run
P- H-style Bypass, Non-Ferrous
S-1 Low Gas Pressure Switch,
Manual Reset
S-2 High Gas Pressure Switch,
Manual Reset
Regulatory Agency Requirements
MVB®- Type P
Pool Heaters
Models 504-2004
Pump included
standard
L
W

Catalog No.: 6000.29B Effective: 7-15-08 Replaces: 1-1-08
MVB – Type P
Models 504-2004 Model
Shown without H-bypass or Cold Water Run options
Dimensions (in.)
MBTUH B D E F G H K M N P R V
Model
Input Output Height NPT NPT Flue Ø C/A Ø
Ship
Weight
(Lbs.)
Foot-
print
(Ft2)
Amps*
P-504 500 420 43 30 35 23-3/4 1 2 8 14-1/8 6 36 8 2 600 5.4 12
P-754 750 630 49 36 41 29-3/4 1 2 10 16 6 42 8 2 660 5.4 12
P-1104 1100 935 55 43 47 35-3/4 1-1/4 2-1/2 10 16 6 49 8 2 720 5.4 12
P-1504 1500 1275 61 50 53 41-3/4 1-1/4 2-1/2 12 18-1/8 8 53 8 2 780 5.4 12
WHP-2004 1900 1615 75 61 65 53-3/4 2 2-1/2 14 20-1/8 8 69 9 5 940 5.4 18
-Ratings shown are for elevations up to 4,500 feet. For installations at elevations
above 4,500 feet, please consult the factory for additional instructions.
* Current draw is for heater only.
(Supply breaker must have delayed trip.)
RATES OF FLOW
20°F ∆
∆∆
∆TMinimum Flow Maximum Flow
Model
GPM ∆
∆∆
∆P (ft.) GPM ∆
∆∆
∆P (ft.) ∆
∆∆
∆T (°F)
GPM ∆
∆∆
∆P (ft.) ∆
∆∆
∆T (°F)
P-504 N/A N/A 65 5.5 13 100 11.3 9
P-754 65 6.4 65 6.4 20 100 13.8 13
P-1104 94 13.6 85 11.5 22 113 18.6 17
P-1504 N/A N/A 102 18.7 25 113 22.2 23
WHP-2004 N/A N/A 102 22.7 32 113 27.2 29
Raypak, Inc.  2151 Eastman Avenue, Oxnard, CA 93030  [phone]  Fax [phone]  www.raypak.com
CLEARANCES
Certified
Minimum
Recomm.
Service
Front 24” 24”
Rear 12” 24”
Right 1” –
Left 1” –
Top 0” 10”
Floor 0” –
Vent 1” –
PUMP
Pump
Model Model HP Amps*
P-504 1611 ¼ 6
P-754 1630 ½ 7
P-1104 1630 ½ 7
P-1504 1634 1 14
WHP-2004 1636 1 ½ 22
* Current draw is for pump only