Raypak D-2 Power Vent User manual

Catalog No.: 1000.70A Effective: 10-15-07 Replaces: 5-1-05
Job:
Engineer:
Contractor:
Prepared By: Date:
Versatile
•For use with pool and spa heaters
•Permits sidewall venting
•Allows use of vent pipe as small as 4 in.
diameter
Efficient
•Maintains thermal efficiency of 82% on all
heater sizes
Multi-Position Capability
•90° elbow can be rotated to align fan
discharge with vent pipe and reduce the
number of fittings required
Features
Induced draft
Vent (Category III) runs up to 100 ft. equivalent length
Plenum sized for appliance capacity
Air flow proving switch, mounted and wired
Fan motor relay, mounted and wired
240/120 Volt, 60 Hz, 1.95/1.0 Amp, 130 CFM Max.,
3200 RPM motor; Factory-wired for 240 Volt
90° elbow is used as a termination cap for
horizontal venting
Heavy-duty galvanized steel cabinet
PolyTuf textured powder coat finish
Indoor/Outdoor construction
Easy installation
Limited one-year warranty
Shipped loose for field mounting
D-2 Power Vent
For Pool & Spa Heaters
Models 206-407

Catalog No.: 1000.70A Effective: 10-15-07 Replaces: 5-1-05
D-2 Power Vent
For Heater Models 206-407 Heater Model
18-1/8
7-7/8
B
4" DIA D
11-5/8
Dimensions (in.)
Heater
Model Power Vent
Part No.* B D
206/207 009832 12-3/8 4-1/4
266/267 009832 12-3/8 4-1/4
336/337 009833 18-1/8 7-1/4
406/407 009833 18-1/8 7-1/4
* Part numbers are for 240 VAC units.
Consult factory for 120 VAC units.
NOTES:
1. All units can exhaust flue gases horizontally or
vertically at up to 100 ft. of equivalent length
vent pipe
- 90° elbow = 10 ft. equivalent length
- 45° elbow = 5 ft. equivalent length
2. Vent pipe must meet Category III appliance
venting requirements.
3. Vent pipe sizes are based on 400°F nominal
flue temperature and sea-level operation. For
installation under other conditions, please
consult the factory.