Razor Dirt Quad User manual

DIRT QUAD BATTERY
INSTALLATION INSTRUCTION
WARNING: Turn off the main power switch before proceeding with the following instructions.
Step 1:
Use the rear carry handle to carefully lift Dirt Quad
up on front end. Using a 5mm allen wrench,
remove the 4 bolts on the bottom of the battery
cover. Using a 3mm allen wrench, remove the 2
bolts on the support bracket (Figure 1). Using the
rear carry handle, slowly lower the Dirt Quad back
down to the ground. Save bolts for reassembly.
Using a 6mm allen wrench, remove the 4 bolts
on the handlebar clamps and detach handle-
bars. (Figure 2)
Step 2:
Need Help? Visit our website for additional instructions at www.razor.com or call toll-free at 866-467-2967 Monday - Friday
8:00am - 5:00pm Pacific Time. 1
Tools Needed: A. 3mm Allen Wrench
B. 4mm Allen Wrench
C. 5mm Allen Wrench
D. 6mm Allen Wrench
E. No. 10 Open Wrench
F. Phillips Head Screw Driver
Figure 1 Figure 2
Step 3:
Using a 5mm allen wrench, remove the 4 bolts
on both sides of the footrest platforms. (Figure 3)
Using a # 10 open wrench, remove the 2 bolts
underneath the rear fender. (Figure 4)
Step 4:
Figure 3 Figure 4
3mm Allen
5mm Allen

Need Help? Visit our website for additional instructions at www.razor.com or call toll-free at 866-467-2967 Monday - Friday
8:00am - 5:00pm Pacific Time. 2
Step 5:
Lift up the plastic body (Figure 5a). Carefully maneuver it around the top of the steering tube (Figure 5b)
Using a Phillips screw driver, remove the 3
screws on the right side (as if riding product) of
the battery cover. (Figure 6)
Step 6:
Figure 5a
Figure 6
Step 7:
Remove both sides of the battery covers. (Figure 7)
Figure 7
Figure 5b

Disconnect the connector between the battery
and the control module (Figure 8)
Step 8:
Figure 8
Need Help? Visit our website for additional instructions at www.razor.com or call toll-free at 866-467-2967 Monday - Friday
8:00am - 5:00pm Pacific Time. 3
Step 9:
Using a 4mm hexagonal allen wrench, remove
the 2 bolts (1 on each side) on the battery strap.
(Figure 9)
Use both hands to carefully lift out the batteries. (Figure 10)
Step 10:
Figure 9
Figure 10
Step 11:
1. Place the new battery inside the battery tray.
2. Re-fasten the battery strap around the battery.
3. Re-connect the battery to the control module.
*Note: Check that all connectors are securely attached, especially to the power switch as it is possible
connector(s) may get detached when lifting up the plastic body.
4. Re-attach the battery cover.
5. Lower the plastic body back down over the main frame and re-fasten the 2 bolts to the to the rear fender.
6. Re-fasten the 4 bolts on both of the footrest platforms.
7. Re-attach the handlebars.
8. Lift Dirt Quad up and re-fasten the bolts to the battery cover and support bracket.
9. Carefully lower Dirt Quad back down; installation complete.
Attention: Charge battery for 18 hours before initial use.