INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY |MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz
2
YOU ARE RESPONSIBLE FOR THE SAFE OPERATION OF THIS UNIT
Attention
For optimum installation use at least 4 suitable screws for each wall-plate. Screws should be
selected to suit the wall type.
Grab Rails are no stronger than the anchors or walls to which they are attached, and therefore,
must be rmly secured in order to support the loads for which they are intended.
Maintenance and cleaning instructions
Do not use detergents containing bleach, acids, alkalis, or chlorine or abrasive products. Do not
use abrasive objects (e.g. scouring pads). Do not use chemicals that can damage plastic. Clean
the surface with water and a neutral detergent; rinse carefully and dry with a clean cloth. If
alternative cleaning methods and/or chemicals are used, warranty may become void.
Important Warnings
Exceeding the maximum load values may cause permanent product damage. If this happens,
cease use until checked by a specialised maintenance person. Improper use, such as for
gymnastic exercises or as a step, may cause accidents with serious consequences. Reliable
operation and product safety depend on the way the products are installed and used.
Ensure installation is performed by qualied personnel. Incorrect installation can seriously
compromise product functionality.
Tools Required
Plumbers Tape
Screw Driver
Extended Driver Bit
Spirit Level
Components Supplied
2x Flange Cover
2x Bracket Post 2x Bolt 6x Screw 6x Pin
1x Rail
2x Wall Plate 2x Flange Button
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY |MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz
3
7. Repeat for other xing
points.
1. Lay rail at with thread
facing up.
8. Mark location to install.
2. Place bracket post onto
rail.
3. Slide ange cover over
post.
4. Insert bolt through wall
plate.
5. Insert xing wall bracket
and assemble.
6. Tighten.
