RC Groups CR-230 User manual

XX-Copter Series
CR-230 Mini Copter
1

ASSEMBLY AND INSTRUCTIONS
Please read carefully before use this mini copter, because different control board have
different operations, So this instructions just explain how to assembly this copter.
Specifications:
Length: 230mm Width: 230mm
Weight: 95g (KIT)
According to the different purpose, The have different configuration, So ou can choose
different propeller, BEC and Motor. Our recommendator configuration as below:
Motor:1800KV 2222
BEC: 10A
Propeller :5030X3
Batter :11.1V 1800mah
2

Safety Precautions:
★This electric R/C model plane is not a to .
★Skill level is designed for the intermediate pilot with some fl ing and building
experience.
★Children ounger than 14 ears old must use it accompanied b an adult.
★Please choose an open place to fl awa from buildings and overhead power
lines.
★Please alwa s put safet first and operate in a safe and reasonable manner.
The battery must be fully char ed before attemptin to fly this model.
Important Safety Note:
When charging the batter , it is important to keep batter and charger under
observation and never to leave them unattended. Disconnect the batter from the
charger when it has finished charging.

Assembly Instructions:
Assemble the propeller in the right place and use fix with cross head screw
provided.
Final Adjustments
1. For safel , ou’d better take off the propeller before adjustment
2. Switch on the transmitter making sure that the throttle stick and throttle trim
tab is in the throttle off position (full down). Centralize all the other trim tabs
3. Insert the flight batter into the radio ba and connect the batter to the speed
controller. You will hear three beeps meaning that all is working well
4. For different Fl -Control board, there have different adjustment method, So ou
can test it b the Fl -Control board manual.

Safety Precautions:
Beginners should seek help and advice from an experienced person.
Choose an area large enough awa from buildings, people, vehicles and
overhead power lines. Alwa s check that our batteries are fresh and charged.
After switching on our transmitter and model check that there is no
interference.
Do not fl in strong winds and choose a fairl calm da for our first flight.
Alwa s disconnect our batter when not in use.
We hope ou have enjo ed assembling this model.