RC Groups Ultra Easy Stik 120 ARF User manual

Ultra Easy Stik - 120 ARF
INSTRUCTION MANUAL
Specifications
Wingspan: 70.9 in
Wing Area: 1,060 sq in
Weight: 9.0 lb
Length: 66.9 in
Engine: 2-stroke .91-1.20
Radio: 4-channel, five servos
Special Notes
•Due to temperature changes during transportation and storage, the airplane you receive
might have wrinkles on the covering. This could be easily removed by applying a little heat
gun and with no adverse effect on performance.
•The pushrods that came with this plane are uncut and unbent. Be sure to cut the pushrods
to the proper length.
•This airplane is intended for intermediate to advanced modelers with experience with
previous airplanes. Please use the same caution and judgments as in your previous ARFs.
•When balancing the airplane, the suggested balance point is 5 in from the leading edge.

2
1. Parts of the airplane
2. Included accessories

3
3. Connect the two piece fuselage using the
included wood sticks
4. Glue the wood sticks
5. Connect the two piece fuselage
6. Glue the joining area
7. Remove the covering over the vertical fin
8. Install the horizontal stabilizer
9. Install the vertical fin
10. Make sure the vertical fin is perpendicular
to the stabilizer

4
11. Add glue to secure the vertical fin
12. Assemble the steerable tail wheel (1)
13. Assemble the steerable tail wheel (2)
14. Secure the tail wheel
15. Install the wheel
16. Install the rudder along the hinges
17. Add glue to secure the rudder
18. Install the elevator

5
19. Install the elevator pushrod
20. Install the elevator control horn
21. Complete the installation of the elevator
control
22. Connect the pushrods and servo arms
23. Complete the install of elevator and rudder
servos
24. Connect the fuel tank
25. Install the fuel tank in the fuselage
26. Secure the engine

6
27. Install the engine pushrod
28. Connect the pushrod to the servo
29. Install the wheel on the landing gear
30. Secure the landing gear
31.Install the receiver switch
32. Install the aileron along the hinges
33. Add glue to secure the aileron
34. Connect the aileron servo extension wire

7
35. Take the extension wire through the servo
opening
36. Take the extension wire out at the other
end
37. Secure the aileron servos
38. Secure the control horn
39. Cut the pushrod to the necessary length
40. Secure the pushrod
41. Aileron servo installation complete
42. Slide the connecting strip into the wing

8
43. Join the two wings
44. Add glue to the join area to secure
45. Join the two servo wires
46. Secure the main wing on the fuselage
47. Installation is complete