Red Kite Baby Go Round Twirl Manual

IMPORTANT!
KEEP FOR FUTURE REFERENCE.
Read the instructions carefully before use and keep them for future reference.
The child may be hurt if you do not follow the instructions.
Adult assembly required.
Instruction Lea et
Baby Go Round
Twirl
Intended to be used by children who can sit unaided, approximately from 6
months. It is not intended for children weighing more than 12kg.
Complies with the relevant parts of: BS EN 1273 : 2005.
Customer Care Line: 01454 326 568.
Baby Go Round

A
To attach the seat unit
Push the 9 seat xings
rmly into the button holes
until they lock in place.
B
To attach the friction strips and wheels
Push the wheels and friction
strips in to the corresponding
holes on the base of the walker.
C
To adjust the walkers height
Lift the top tray upwards away from the base
quickly. This should put it in the highest height
position.
To adjust the height, turn the button and then
press inwards. When a new height has been
reached, the lock button will automatically turn
back to the locked position.
To collapse the walker turn the button, press
inwards and lower the top tray towards the base.
D
Toy assembly
Push the
toys in to the
recesses on
the toy tray
until they click
in place. The
cup cake
locks in place
by turning it.
E
Attaching the toy tray
Slot the toy tray in to the
recess. Push up the key
under the tray and turn 90
degrees.

General Care:
•The correct use and maintenance of this walker is
essential.
•Ensure that both of the child’s feet reach the oor.
•Do not use excessive force when adjusting the
walker.
•Always store the walker in a dry place.
•Individual toys on the toy tray are not replaceable.
•Do not alter the toy tray by adding toys or cutting
existing ones away, this could be dangerous.
Cleaning:
•The seat unit may be spot cleaned by using a
sponge with a mild soap and warm water solution.
Leave to dry in a ventilated area away from direct
sunlight. Do not dry clean, machine wash, bleach or
tumble dry.
•Metal parts may be cleaned with a damp cloth.
Always wipe dry.
•Clean plastic parts with a mild soap and warm
water solution.
•Avoid leaving the walker in direct sunlight for
prolonged periods of time as this may cause
fabrics to fade.
Maintenance:
• Check that nothing is loose or broken and that no
sharp edges have been exposed. Replace any
damaged parts immediately.
•Routinely inspect all studs, nuts and screws for
tightness. Check the seat attachment points,
ensure they are secured.
•Never use this product without the friction blocks.
•Do not use replacement parts other than those
approved by the manufacturer or distributor.
Failure to do this may invalidate your warranty.
Safety Warnings:
•WARNING - Never leave the child unattended.
•WARNING - The child will be able to reach further
and move rapidly when in the baby walking frame.
•WARNING - Your child’s safety is your
responsibility.
•Prevent access to stairs, steps and uneven
surfaces.
•Guard all res, heating and cooking appliances.
•Remove hot liquids, electrical exes and other
hazards from reach.
•Prevent collisions with glass in doors, windows and
furniture.
•Do not use the baby walking frame if any
components are broken or missing.
•This baby walking frame should be used only for
short periods of time (e.g. 20 min).
This product complies with: BS EN 1273 : 2005
Imported by
The Red Kite Baby Co Ltd
35 Lavenham Road
Beeches Industrial Estate
Yate
Bristol
BS37 5QX