Safety instructions
Receipt and unpacking
Unpack the device without damaging it and check whether the device type corresponds to the one ordered. The packing should always
follow the device until this has been permanently mounted.
Environment
The device is manufactured for indoor use. Avoid direct sunlight, dust, high temperatures, mechanical vibrations and shock, as well as
rain and heavy moisture. If necessary, heating in excess of the stated limits for ambient temperatures should be avoided by way of
ventilation.
The device may be used in Overvoltage Category II, Pollution Degree 2 at an altitude up to 2000 m.
Mounting
Only qualified technicians who are familiar with the technical terms, warnings, and instructions in this installation guide and who are
able to follow these should connect the device. Only devices which are undamaged and free of moist and dust may be installed. The
device may be installed and supplied by Red Lion IAMS and AFCM series only.
Should there be any doubt as to the correct handling of the device, please contact your local distributor or, alternatively,
Red Lion Controls
www.redlion.net
Calibration and Adjustment
During calibration and adjustment, the measuring and connection of external voltages must be carried out according to the
specifications of this manual. The technician must use tools and instruments that are safe to use.
Cleaning
When disconnected, the device may be cleaned with a cloth moistened with distilled water.
Liability
To the extent the instructions in this manual are not strictly observed, the customer cannot advance a demand against Red Lion
Controls that would otherwise exist according to the concluded sales agreement.
Special Condition of Use:
1) In Class I, Division 2 installations, the subject equipment shall be mounted within a tool-secured enclosure which is capable of
accepting one or more of the Class I, Division 2 wiring methods specified in the National Electrical Code (ANSI/NFPA 70) or Canadian
Electrical Code (C22.1)
2) In Class I, Zone 2 installations, the subject equipment shall be mounted within a tool-secured enclosure which is capable of
accepting one or more of the Class I, Zone 2 wiring methods specified in the National Electrical Code (ANSI/NFPA 70) or Canadian
Electrical Code (C22.1).
The equipment shall be installed in an enclosure with a minimum ingress protection rating of IP54 unless the apparatus is intended to
be afforded an equivalent degree of protection by location.
Conditions particulières d’utilisation :
1) Dans les installations de classe I, division 2, l’équipement visé doit être installé dans un boîtier protégé par un outil pouvant
accepter une ou plusieurs des méthodes de câblage de classe I, division 2 spécifiées dans le Code national de l’électricité (ANSI/
NFPA 70) ou le Code électrique canadien (C22.1).
2) Dans les installations de classe I, zone 2, l’équipement visé doit être monté à l’intérieur d’un boîtier protégé par un outil
pouvant accepter une ou plusieurs des méthodes de câblage de classe I, zone 2 spécifiées dans le Code national de l’électricité
(ANSI/NFPA 70) ou le Code électrique canadien (C22.1).
L’équipement doit être installé dans un boîtier dont l’indice de protection est d’au moins IP54, à moins que l’appareil ne soit
destiné à recevoir un degré de protection équivalent selon l’emplacement.
LP1097 5
