Red Shed 1981481 User manual

1 PC
A
1 PC
B
1 PC
C1
BASE SCREW WASHER ALLEN
WRENCH
2
1 PC
3
2
1 PC
1
2 PCS
4
1 PC
1 PC
C2
1.
1
1
B
C1
RS PLASTIC OUTDOOR
PATIO UMBRELLA STAND
1981481
10
PRODUCT ASSEMBLY
TIGHTENING
KNOB
Take out the Plastic Base (A) and check the components as illustrated.
a, If the dimension of umbrella tube is 1.9″, just put 1.9" Pipe Sleeve (C1) into the Extend Pole (B).
b, If the dimension of umbrella tube is 1.5″, put 1.5" Pipe Sleeve (C2) into C1, and then put them
together into the Extend Pole (B). Then attach 2 pcs of Tightening Knobs (Part 1) to fix the Pipe Sleeve.
1
1
B
C1
C2
a b
PLASTIC BASE EXTEND POLE 1.9″ PVC
PIPE SLEEVE
1.5″ PVC
PIPE SLEEVE

NOTICE
· Only fill with water when used in warm climates.
· Do not fill with water if exposed to freezing temperatures.
· Formation and expansion of ice may crack the base.
· Check weight each season and refill as needed.
· Capacity : Sand 50 lbs/Water 15L
2. Put the Extend Pole (B) into the Plastic Base (A), attach the Washer (Part 3) and Base Screw (Part 2)
using Allen wrench.
B
A
2
3
4
3. Take off the cap to fill in with sand or water. Seal the cap back. You finish the assembly!
SAND
WATER
OR
CAUTION: The plastic base will be very heavy after filling with
sand or water. Be very careful when moving these plastic bases in
case of hurting your feet or destroying the plastic base.