Red Stone FH16P-DM User manual

RedStone Ceramic Barrel Heater
OWNER’S MANUAL
Model No. FH16P-DM
SKU. 1241593
PLEASE SAVE THESE INSTRUCTIONS
WARNING: READ THIS OWNER’S MANUAL CAREFULLY BEFORE USE.

2
Thank you for choosing our Ceramic Barrel Heater. This owner’s manual will provide
you with valuable information necessary for the proper care and maintenance of your
new product. Please take a few moments to thoroughly read the instructions and
familiarize yourself with all the operational aspects of your new heater.
PLEASE SAVE THESE INSTRUCTIONS

3
IMPORTANT SAFETY INSTRUCTIONS
READ AND UNDERSTAND ALL INSTRUCTIONS,
SAFETY WARNINGS, BEFORE USING THE HEATER
WARNING!
! POTENTIAL FOR ELECTRICAL HAZARD IF NOT
ADHERED TO!
When using this electric unit, basic safety precautions should always be followed to
reduce the risk of fire, electric shock, and injury to persons, including the following:
1. Read ALL instructions before using this unit.
2. CAUTION: Risk of Electric Shock. DO NOT open or try to repair the heater
yourself.
3. This heater may get hot when in use. To avoid burns, DO NOT let bare skin
touch hot surfaces. If provided, use handles when moving this heater.
4. Keep combustible materials, such as furniture, pillows, bedding, paper, clothes,
and curtains at least 3 ft from the front of the heater and keep them away from
the sides, top, and rear. DO NOT place towels or other objects on the heater.
5. Extreme caution is necessary when any heater is used by or near children or the
disabled, or when the heater is left operating and unattended.
6. DO NOT operate any heater with a damaged cord or after the heater
malfunctions, has been dropped or damaged in any manner. Return heater to
authorized service facility for examination, electrical or mechanical adjustment,
or repair.
7. This heater is not intended for use in bathrooms, laundry areas and similar
indoor locations. NEVER locate heater where it may fall into a bathtub or other
water container. To protect against electrical hazards, DO NOT immerse in
water or other liquids.
8. DO NOT touch the control panel or plug with a wet hand.
9. DO NOT run cord under carpeting. DO NOT cover cord with throw rugs, runners,
or similar coverings. Arrange cord away from traffic area and where it will not be
tripped over.
10. DO NOT insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or fire, or damage the heater.
11. To prevent a possible fire, DO NOT block the air intakes or exhaust in any

4
manner. DO NOT use on soft surfaces, like a bed, where openings may become
blocked.
12. A heater has hot and arcing or sparking parts inside. DO NOT use in areas
where gasoline, paint, explosive and/or flammable liquids are used or stored.
Keep unit away from heated surfaces and open flames.
13. Always plug heaters directly into a wall outlet/receptacle. Never use with an
extension cord or relocatable power tap (outlet/power strip).
14. To avoid fire or shock hazard, plug the unit directly into a 120 V AC electrical
outlet.
15. To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull
firmly on the plug, DO NOT unplug by pulling on the cord.
16. Always unplug the unit before moving or cleaning, or whenever the heater is not
in use.
17. Use only for intended household use as described in this manual. Any other use
not recommended by the manufacturer may cause fire, electric shock, or injury
to persons. The use of attachments not recommended or sold by unauthorized
dealers may cause hazards.
18. Always use on a dry, level surface. Use on floor only.
19. DO NOT use outdoors.
20. WARNING: To reduce the risk of fire or electric shock, DO NOT use this unit
with any solid-state speed control device.
21. DO NOT attempt to repair or adjust any electrical or mechanical functions on this
unit. Doing so will void your warranty. The inside of the unit contains no user
serviceable parts. Qualified personnel should perform all servicing only.
SAVE THESE INSTRUCTIONS

5
SPECIFICATIONS
Voltage Rating
120V (60Hz)
Power
Consumption
1500W (25℃)/1650W (0℃ )
Unit Size
7.48in. (L)× 8.66 in. (W) × 8.66in. (H)
Unit Weight
4.6lbs
SAFETY FEATURES
Overheat Safety Feature
This heater is equipped with an overheat safety feature. When the heaters internal
components reach a certain temperature that could cause overheat and possible fire,
the heater will automatically shut off.
WARNING: It is normal for the power cord to feel warm to the touch; however, a loose
fit between the outlet and the plug may cause overheating of the plug. If this occurs, try
inserting the plug into a different outlet. Contact a qualified electrician to inspect the
original outlet for damage.

6
IN THE BOX
·PTC HEATING SYSTEM
·INSTRUCTION BOOKLET
PRODUCT DIAGRAM
Power
Control Dial
Thermostat
Control
C
Power Indicator
Light
Caution
Light
Hot Air
Outlet

7
ASSENBLY
Simple assembly is required before you use this heater.
Instruction for Use
1. Connect the heater and get it started;
2. Rotate the adjustable thermostat clockwise. Turn the thermostat knob to the position
"HIGH";
3. Users can turn the switch clockwise to the position “FAN” or “LOW” or “HIGH”
according to their needs. The power indicator light is on when the product is working.

8
MAINTENANCE
1. Turn off rotary switch.
2. Unplug the unit and let it cool completely.
3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth.
You may use a mild detergent if necessary. After cleaning, dry the unit with a
soft cloth. CAUTION: DO NOT let liquid enter the heater.
4. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough
brushes to clean the heater. This may cause damage or deterioration to the
surface of the heater.
5. DO NOT immerse the heater in water.
6. Wait until the unit is completely dry before use.
TROUBLE SHOOTING
If the heater will not operate, please check the following before seeking repair advice:
1. Check if the power cord is plugged into an electrical outlet, if not, plug in.
2. Check the power of the main power indicator light (in front of) work.
3. Overheat protection function may have been triggered. Try to press the power
button, if the heater does not turn on, clear any obstructions from front and rear
of heater that may have caused internal overheating. To restart the heater,
unplug it to cool for 5-15 minutes, then plug in again. Make sure the obstruction
removed before restarting.
STORAGE
Store the heater in a cool, dry location when not in use. To prevent dust and dirt build-
up, use the original packaging to repack the unit.