Redrock TruShield User manual

TruShield Pet Barrier Net
Installation Guide for Jeep Wrangler '07-'16 2-Door JK
Installation Time: <1 Hour
Tools Required:
Box Cutter/Knife
Pliers (optional)
Installation Instructions:
1. Carefully open the package using a box cutter or knife (Figure A) and ensure the product is included and
undamaged.
Figure A
2. Lay the netting out flat and find the Barricade label (Figure B).

Figure B
3. Pull the front seats all the way forward (Figure C).

Figure C
4. If installing on a hardtop, it may be easier to install if the two front hardtop panels are removed (Figure D).

Figure D
5. With the Barricade logo facing the rear of the vehicle and in the top passenger-side corner, run the top right
strap over the sound bar (front to rear) (Figure E).
Figure E
6. Retrieve the strap on the other side of the sound bar and pull down (Figure F).

Figure F
7. Run the retrieved strap through the buckle at the bottom of the same strap (Figure G).
Figure G
8. Follow steps 5-7 on the left side, as well.

9. On the bottom of the netting, find the strap with a metal hook and secure it around the outer seat bracket on
both the driver and passenger seats (Figure H).
Figure H
10. Tighten all straps (Figure I). Optional: Use pliers for additional leverage in tightening the netting straps.

Figure I

Before After
Installation Instructions Written by ExtremeTerrain Customer J. Sandlin 12/20/2017