Reelworks L430302 User manual

Instruction Manual
REV 08/28/18
WARNING:
Read carefully and understand all INSTRUCTIONS before operating. Failure to follow the safety
rules and other basic safety precautions may result in serious personal injury.
Save these instructions in a safe place and on hand so that they can be read when required.
Keep these instructions to assist in future servicing.
Steel Hand Crank Hose Reel

GENERAL SAFETY REGULATIONS
WARNING: The warnings, cautions, and instructions
discussed in this instruction manual cannot cover all
possible conditions or situations that could occur. It
must be understood by the operator that common
sense and caution are factors that cannot be built into
this product, but must be supplied by the operator.
1. Keep the work area clean and dry. Damp or wet work areas can result in
injury.
2. Keep children away from work area. Do not allow children to handle this
product.
3. Use the right tool for the job. Do not attempt to force small equipment to do
the work of larger industrial equipment. There are certain applications for
which this equipment was designed. It will do the job better and more safely
at the capacity for which it was intended. Do not modify this equipment, and
do not use this equipment for a purpose for which it Was not intended.
4. Check for damaged parts. Before using this product, carefully check that it
will operate properly and perform its intended function. Check for damaged
parts and any other conditions that may affect the operation of this product.
Replace damaged or worn parts immediately.
5. Do not overreach. Keep proper footing and balance at all times to prevent
tripping, falling, back injury, etc.
6. DO NOT use the equipment when tired or under the influence of drugs,
alcohol, or medication. A moment of inattention while operating this
equipment may result in serious personal injury

TECHNICAL DETAILS
SAFETY PRECAUTIONS
1. Make sure incoming pressure does not exceed the rated pressure.
2. Use the proper eye protection when assembling and using the hose reel.
3. Assemble the hose reel on a clean workbench free of debris and moisture.
4. Use soap liquid when checking for air leakage.
5. Keep children away from the work area.
WARNING: Exposure of skin directly to pressurized air, or fluid could result in severe
bodily injury.
INSTALLATION AND ASSEMBLY
Note: You will need to purchase appropriate hardware part for mounting your new reel.
You will also need to supply hose for the reel. Refer to specification to determine the correct
hose length.
Refer to appendix for assembly.
1. Apply Teflon tape or pipe sealant to reel hose fitting threads. Attach this hose to the inside
end of axle, and tighten.
2. Put the lead hose onto the swivel, then screw down the lead hose fitting onto the swivel to
tighten the lead hose. Feed the long hose through the drum opening, then wrap the hose on
the drum.
3. Feed the long hose through the drum opening, then wrap the hose on the drum. Hose length
should be 100 feet or less.
LIMITED WARRANTY
1. The manufacturer warrantees this hose reel against defects in material and craftsmanship,
for a period of 12 months from date of purchase.
2. Hose, if supplied with reel, and O-rings are deemed to be normal wear items; not warranted.
3.
Manufacturer’s liability is limited to replacement or repair of defective material within the warranty
period, when returned freight prepaid to the distributor or their designated service depot.
4. The warranty does not cover damage caused by accident or misuse or faulty installation.
5. The reel must be installed and maintained in compliance with these instructions.
Item No.
L430302
L430303
Hose is not included
Hose is not included
5/16"/8mm
3/8"/9.5mm
Max Pressure Hose Capacity
Material I.D. Length
100ft/30m
100ft/30m
Inlet/Outlet
1/4"
1/4" or 3/8"
300Psi (20Bar)
300Psi (20Bar)
180 [7"]
100 [4"]
262 [10.3"]
297 [11.7"]
364 [14"]
330 [13"]
E1
TECHNICAL
DETAILS
SAFETY
PRECAUTIONS
LIMITED
WARRANTY
EXPLODED AND
PARTS LIST
INSTALLATION AND
ASSEMBLY

EXPLODED AND PARTS LIST
E2
TECHNICAL
DETAILS
SAFETY
PRECAUTIONS
LIMITED
WARRANTY
EXPLODED AND
PARTS LIST
INSTALLATION AND
ASSEMBLY
Part No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Description
Frame assembly
Flange
Bearing assembly
Swivel sub-assembly
Screw
Spring lock washer
Screw
Spring lock washer
Screw
Reel-core assembly
Spring
Screw
Washer
Handle axle
Handle
"E" ring
Q’ty
1
2
1
1
8
14
1
1
6
2
1
1
1
1
1
1
Part No.
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
Description
Lock pin
Spring
Washer
Lock sleeve
Bolt
Screw
Support axle assembly
Bolt
Steel ball
Washer
Spring lock washer
Nut
Base assembly
Nut
Spring lock washer
Q’ty
1
1
1
1
2
1
1
1
31
1
1
1
1
2
2
49
5 6
3
10 11 12
13
2
16
15
14
17
18
19
20
21
22
1
25
29
24
26
27
28
31
30
8
7
23
Size: 145x210mm REV 08/28/18 3.02.01.055157克铜版纸