The cloud configuration is mainly used for communication with LoRaWAN service.
The gateway can connect to any LoRaWAN server following below steps:
1. Log in TTN, and on console, click gateways. Then add gateway:
2. Set gateway information as below:
3. Create gateway on TTN, and you can see information as below:
4. Set server information on gateway web service as below:
Please check the power adaptor and the cable is right connected.
The USB to serial driver is not installed or the driver is installed incorrectly. Please reinstall the driver. The USB
port is damaged. Please replace other USB ports and try again. For example, windows can check whether USB
recognition is normal through the computer device manager.
If the static IP of the gateway is unavailable, mainly check whether the network segment configuration of the
computer end is correct, there are two network ports on the gateway, and whether the patch cord corresponds to
the IP segment. In addition, the PC can be used to test whether the communication with other devices in the
same network segment can ping to prevent the firewall or anti-virus software from blocking the connection; You
can also directly close the firewall or antivirus software and try again, or disable the computer wired network and
then turn it on.
The package list for GL600 as below:
1．GL600 gateway
2．Sucker antenna*2
3．Power adaptor*1
1. Due to the high-sensitivity electronic components inside the product, the transportation and loading and
unloading shall not be severely impacted.
3.5. Cloud Configuration
4. Connecting to LoRaWAN Server
FAQ
4.1. Abnormal fault analysis
4.1.1. Power indicator is not on
4.1.2. The COM port device cannot be found in the device manager
4.1.3. Gateway Ping failed
5. Package and Transportation
5.1. Package list
5.2. Transportation and Storage
