Remington HC9105 User manual

I www.remington.co.uk
HC9105
I www.remington.co.uk
Register online for an EXTRA year guarantee
Visit uk.remington-europe.com/product-registration You must register within 28 days of purchase.
Heritage Hair Clipper

2
ij
e
f
g
k
l

3
Thank you for buying your new Remington® product. Please read these instructions
carefully and keep them safe. Remove all packaging before use.
IMPORTANT SAFEGUARDS
• This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall not be done by children
unless they are older than 8 and supervised. Keep the appliance and cable
out of reach of children under 8 years.
• Always check the appliance before you use it. Do not use the appliance if it
is damaged, as this may cause injury.
• The adaptor contains a transformer. Do not cut off the adaptor to replace it
with another plug, as this causes a hazardous situation.
The appliance is suitable for cleaning under an open water tap.
• The body of this appliance is not washable or water resistant. Do not put
the appliance in liquid.
• WARNING: Detach the appliance from the charging adapter before cleaning
it in water.
• Do not use the product with a damaged cord. A replacement can be
obtained via our International Service Centres.
• WARNING: For recharging the battery, only use the charger supplied with
the appliance - type reference PA-0515U/SW-050150BS (UK).
• Always replace a damaged adaptor with one of the original type.
• Do not use the appliance if it is damaged or malfunctions.
• Do not use attachments other than those we supply.
• This appliance should never be left unattended when plugged into a power outlet,
except when charging.
• Keep the power plug and cord away from heated surfaces.
• Do not plug or unplug the appliance with wet hands.

4
PARTS
1. On/o switch
2. Detachable blade set
3. Taper lever
4. #0—#8 professional grade guide combs
(1.5-25mm)
5. Left and Right ear taper combs
6. Charging indicator
7. Blade release button
Not shown:
• Storage pouch
• Adaptor
• Oil
• Cleaning brush
• Face towel
• Blade guard
GETTING STARTED
CHARGING YOUR APPLIANCE
• Ensure the product is switched o.
• Connect the shaver to the adapter and then to the mains.
Charging indicator
Charge Level Indicator
Charging LED will ash blue
Low battery LED will ash red
Fully charged LED will go out
• Run time from fully charged is up to 60 minutes.
• Charge time from empty is 4 hours.
• To preserve the life of your batteries, let them run out every 6 months then recharge
for 4 hours.
CORDED USE
• Connect the charging adaptor to the product then to the mains.
• When the cord is connected to the mains, the charging indicator light will turn o if
the product is turned on.
CAUTION
Extended mains only use will result in the reduction of the battery life.

5
INSTRUCTIONS FOR USE
Before starting the cut
• Inspect the clipper making sure that it is free from hair and dirt.
• Seat the person so that their head is approximately at your eye level.
• Before cutting, always comb the hair so it is tangle free and dry.
TO ATTACH A COMB
• Hook front side of attachment comb on front side of teeth.
• Press back side of comb downwards, until the tab clicks into place.
TO REMOVE THE COMB
• Press upward on the tab to release the comb.
• With tab released, pull comb away from clipper and unhook front of the blade.
INSTRUCTIONS FOR CUTTING HAIR
• For even cutting, allow the comb attachment/blade to cut its way through the hair.
Do not force it through quickly. If you are cutting for the rst time, start with the
maximum comb attachment.
STEP 1 – Nape of the neck
• Attach the 3mm or 6mm xed comb
• Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre
of the head at the base of the neck.
• Slowly lift the clipper, working upwards and outwards through the hair, trimming
just a little at a time.
STEP 2 – Back of the head
• With the 12mm or 16mm guide comb attached, cut the hair at the back of the head.
STEP 3 – Side of the head
• With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the
longer 9mm guide comb and continue to cut the top of the head.
STEP 4 – Top of the head
• Use the longer length xed combs of 22mm or 25mm to cut hair on top of the head
against the direction in which the hair normally grows.
• Always work from the back of the head.
STEP 5 – The nishing touches
• Use the clipper without an attachment comb for close trimming around the base and
sides of the neck.
• To produce a clean straight line at the sideburns, reverse the hair clipper. Place the
reversed clipper at right angles to the head, tips of the blades lightly touching the
skin and then work downwards.