ReneSola RTL009CB0101 User manual

1. This product must be installed in accordance with the
national and local codes and ordinances.
2. Turn off power supply before installation or servicing.
3. Proper grounding is required to ensure personal safety
1. Installers must be qualified electrical professionals, to prevent
electric shock or fire risk
2. Wear gloves when installing the fixture to prevent injury.
3. Contact a qualified electrical professional to reconfigure if there
is smoke or flames coming from the wire.
1. Open the product package to check for damage. If the product
has been damaged during transportation please contact the
manufacturer immediately.
2. Check that all the accessories have been included as per the
instructions. Please install as per the instructions.
ᶀ䍘˖*Җ߉㓨ˈৼ䶒ঠࡧˈቪረ$
INSTRUCTION MANUAL INSTRUCTION MANUAL
INSTRUCTION MANUAL INSTRUCTION MANUAL
Installation:
Caution:
Attention:
Product Specification:
Product Size:
Notice:
To ensure proper usage, please carefully read and keep this instruction
manual for future reference.
LED PANEL LIGHT
RTL009CB0101
RTL009CB0102
RTL012CB0102
RTL012CB0101
9W
12W
120V 60Hz
121*24mm
175*24mm
3000K
4000K
3000K
4000K
Model Power Input
Voltage Frequency Product Size
 CCT

H
ALLATION
1. Connect the fi xture to the hardwire box by inserting and
twisting the malefemale connectors. Fig.3
2. Push spring loaded clips on the fi xture upwards and insert

fixture base in to the mounting hole.Release the clips and
fixture will be pulled flush to the ceiling. (Fig.4)
working properly.
WIRING:
appropriate knockout(s).
2. Insert the electrical supply cable through the knockout and
secure with a cable connector sold separately
3. Using wire nuts,connect green ground wire of cable to green
wire on box.Connect white wire of cable to white wire of
box.Connect black wire of cable to black wire of box.Fig.1
4.Place all wiring and connections back in to the box and close
the cover.
5. Insert hardwire box through the mounting hole. Fig.2
New construction applications:
 Hardwire box shall be

firmly secured to studs joists, or similar fixed structural
units.
Remodel applications:

be firmly secured after the mounting plates studsjoistsor
structural units have been concealed.
1. Open the hardwire box swing cover and remove the

3. Once assembly is complete, turn on power to confirm fixture is
Opening Size
!"##
$"##