RF Elements MiMo Sector User manual

Instruction Manual MiMo Sector Antennas
www.rfelements.com
Package Contains:
Assemble the Bracket to the Antenna Body using M6 Screws
Use Pole Clamps and M8 Screws, Bolts and Washers to
install the Antenna.
ATTENTION: Pole Clamps and Bracket are made of diecast
aluminium, very rigid material without ability to bend.
Pole Clamps, Bracket and M8 Screws can create serious
pressure towards the pole. Using moderate tightening
force on nuts can cause deformation of poles with low
wall thickness. Using extensive tightening force on
bolts, you can damage the pole or crack the pole clamps.
Please consider that Antenna is very light and Bracket-
Pole Clamps-Screws setup is intentionally oversized. You
don´t need to push the parts to the limit to achieve very
stable installation of the Antenna.
1. M6 Screws
2. M8 Screws, Bolts and Washers
3. Pole Clamps (2x)
4. Bracket
5. Protection Cap
6. Pigtails
7. Antenna Body
1 Assemble the Antenna
2 Install the Antenna
1 2
3 7
4
5
6

A Uninstall the GPS cover and Rocket-compatible Mount from the back of the
Antenna.
B Install Rocket GPS antenna, install the pigtail into the groove. Coil remaining
part in the compartment. Needle out only the appropriate part of GPS pigtail
with connector.
C Install GPS cover and Rocket-compatible Mount back to their positions.
Follow Up the rest of Installation Procedure as described in section 3.
To remove RockeTik or Rocket from the mount, use tool to release the mount´s lock.
Any rm object that ts the gap could be used: screwdriver, wrench, knife etc.
3 When using UBNT Rocket or RF elements RockeTik:
A Snap the Rocket/RockeTik on the Rocket-compatible Mount on the back
of the Antenna
B Use Pigtails to interconnect Rocket/RockeTik and Antenna Ports
C Snap the Protection Cap to the Position
Instruction Manual MiMo Sector Antennas
4 When using UBNT Rocket GPS:
5 How to remove device from the Antenna
www.rfelements.com