RF Elements StationBox XL User manual

StationBox®XL Installation Instructions
www.rfelements.com
Package Contains:
1 Disassemble the StationBox® XL: Push cover locks and remove the cover. Remove the Chassis using the Chassis Tool. Screwdriver or coin will work too.
2 Integrate the RouterBoard with Chassis: Install LED light guides according to RouterBoard setup. Secure the Routerboard using 4 screws.
Body
1 × Security
Screw
1 × Security
Screw
2 × Hose
Clamps
4 × Wall
Plugs &
Screws
Chassis Tool
Rubber Brake
Cover
Chassis
4 × Screws
LED light Guides
Bracket
3 Connect the RouterBoard with Antenna:
Connect the pigtails between antenna connectors and radio ports.
SBX XL 2.4GHz:
Port B - Horizontal
Port C - Vertical
SBX XL 5GHz:
Port B - Vertical
Port C - Horizontal
SEP13

Check the product videos at YouTube: www.youtube.com/RFelementscom
www.rfelements.com
4 Insert the Chassis into the StationBox.
Insert pigtails rst, then slide the Chassis.
5 Use the Security Screw to secure the
Chassis (optional).
6 Connect the ethernet cable. In case of
more cables, knock o the premolded
positions in the Cover.
7 Close the Cover. Make sure the side locks
lock properly.
8 Install the Bracket on the
Pole or on the Wall. Insert
the Rubber Brake.
9 Attach the StationBox to the Bracket and slightly
tighten the Nut. You should be able to move the
StationBox.
10 Now you can smoothly position the antenna
in 3-Axis. Set the desired elevation, azimuth
and rotation by moving the StationBox
using the Ball joint.
11
While holding the StationBox in desired
position, tighten the Nut as much as you can.
Optional: To secure the position, use Security
Screw that cuts in the Ball part of
the bracket.
SEP13