RH Baby&child CHESTERFIELD DAYBED FULL User manual

Qty
NO.
1
DESCRIPTION
The hardware is packed with the Side Rails (A)
1 Pc.
2
TOOLS NEEDED:
Phillips head Screwdriver (not included)
PARTS INCLUDED
ASSEMBLY INSTRUCTIONS
Bed must be assembled by at least two people.
Please read instructions carefully before assembling bed.
Use the above parts and hardware list to identify each component.
Keep all packing materials until assembly is complete to avoid loss of smaller parts.
There are (2) replacement buttons included. Keep out of reach of children. Professional rework is recommended.
Page 1 of 2
1. Cover the floor with a protective material to prevent damage. Place the Headboard (C) flat on the protective material.
2. Stand the Headboard (C) upright and hook Side Rails (A) into Headboard (C) as shown in the Diagram I.
3. Repeat the procedure with the Footboard (B) as shown in Diagram II.
4. Attach the Center Support Slat Foot (F) to the Center Support Slat (D) as shown in Diagram III.
5. Place the Center Support Slat (D) into the U shaped brackets on Side Rails (A). ighten with Screw (3), as shown in Diagram IV.
6. Place the Slat Roll (E) into the cleats on the inside of the Headboard (C) and Footboard (B). Screw the end of the slats to
Screw (3cm) Pcs.
Allen Key
3Screw (5cm) 2 Pcs.
the cleats using Screws (1), as shown in Diagram V.
CHESTERFIELD DAYBED FULL - ASSEMBLY INSTRUCTIONS
A. SIDE RAILS (2)
B. FOOTBOARD (1)
C. HEADBOARD (1)
E. SLAT ROLL (1)
D. CENTER SUPPORT SLAT (1)
F. CENTER SUPPORT SLAT FOOT (WITH ADJUSTABLE GLIDE) (2)
-
T T
-

Thank you for your purchase
www.rhbabyandchild.com
Page 2 of 2
Thank you for your purchase
www.rhbabyandchild.com
Page 2 of 2
Thank you for your purchase
www.rhbabyandchild.com
Page 2 of 2
Diagram II
Diagram I
Diagram III
Diagram IV
Diagram V
1
3