RH Baby&child MARLOWE User manual

MARLOWE SLEIGH BED WITH LOW FOOTBOARD
WARNING:ADULT ASSEMBLY ONLY OWING TO THE PRESENCE OF SMALL PARTS, SHARP
POINTS AND EDGES
Customer Service- If you are missing parts or have any questions about this product, please contact us
at : 1-800-762-1751
PART LIST
A [1] HEADBOARD
B [2] FOOTBOARD
C [2] SIDE RAILS
D [1] SLAT ROLL
TOOLS NEEDED
- Screwdriver
HARDWARE LIST
Curved slotted washer
Threaded rod
Wrench
Wood screw
ASSEMBLY INSTRUCTION
Note: Bed can be assembled by one person rather easily, but if two people are available it is a bit
easier and the operation will require less preparation. The instructions are written assuming one
person is assembling the bed.
1. Place the headboard (A) upright in the position you wish the bed to be in when fully assembled.
The headboard bedfast hardware should be facing the inside, toward the mattress. Secure the
threaded rod (F) to the Headboard (A). Raise the Side rail (C) up and place the rod into the Side rail
(C) at the bore holes’ position, insert Curved slotted washer (E) and tighten hex nuts using wrench
(G). Repeat the procedure with the other side rail end and Footboard (B).
-Page 1 of 2-

2. Lay the slat roll (D) in between the side rails (C) and use wood screws (1) to fasten 2 end slats to
the side rails with a screwdriver.
Thank you for your purchase
www.rhbabyandchild.com
-Page 2 of 2-