RH Baby&child CALLUM BOOKCASE User manual

CALLUM BOOKCASE INSTRUCTIONS
ASSEMBLY INSTRUCTIONS:
Insert Shelf Clips (1) into the holes in the
Bookcase (A). Place each Wooden Shelf (B) onto
Shelf Clips (1). Using Screw (2), and Phillips Head
screwdriver, tighten each clip.
Note: Remove the screws from the shelf clips to
adjust the placement of wooden shelves
PA R TS INCLUDED:
A [1] BOOKCASE
B [3] WOODEN SHELF
TOOLS NEEDED:
Phillips Head Screwdriver (not included)
Phillips Head Screwdriver (not included)
1
2
3
4
5
6
7
Shelf clip
Page 1 of 2
12 pcs.
Screw 7 x 15mm 12 pcs.
Plastic anchors 4 pcs.
Plastic brackets
Restraint straps
Phillips screws M4 x 30mm
Phillips screws M4 x 20mm
4 pcs.
2 pcs.
4 pcs.
4 pcs.
NO. ITEM DESCRIPTIONQTY.
2
1
B
AB
B
B
A

CALLUM BOOKCASE INSTRUCTIONS
CARE INSTRUCTIONS:
ASSEMBLY INSTRUCTIONS:
WARNING:
This product is only a deterrent. It is not a substitute for proper adult supervision.
FURNITURE TIPPING RESTRAINT:
Young children may be injured by tipping furniture and the use of a tipping restraint is highly recommended. When properly
installed, this restraint could provide protection against the unexpected tipping of furniture due to small tremors, bumps or
climbing. We recommend mounting this restraint to a wall stud.
1. Attach one of the mounting brackets near the top back edge of the furniture piece by inserting the shorter screws.
2. Determine the final position of the furniture piece. Mark location on the wall approximately 2" below the bracket
mounted to the back of the furniture.
3. Drill a starter hole into the wall stud. If wall stud is not available, drill a hole into the wall and insert plastic anchor.
Gently tap the anchor until the flange of the anchor is flush with the wall.
4. Attach the second bracket by inserting the longer screw through the bracket and into the wall.
5. Place the furniture so the bracket on the back edge is in line with the bracket in the wall.
6. Lace one end of the nylon restraint strap down through each bracket. Bring both ends together and slide the eaded
end until it snap locks into the keyhole slot.
7. To double lock; return the beaded end back through the keyholes as shown.
8. Check to make sure the Restraint strap is securely laced and locked to the brackets.
9. To adjust the wooden shelf, remove the wood screws from under the shelf pegs.
1. Dust often using a clean, soft, dry lint-free cloth.
2. Blot spills immediately, and wipe with a clean, damp cloth.
3. We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our lacquered finish.
Phillips Head Screwdriver
(not included)
Page 2 of 2
5
6
7
3
A
4