RH THADDEUS FORGED BRASS User manual

Page 1 of 2
Thank you for choosing this quality product. Be sure to check all packaging materials carefully for small parts that may have
become loose during shipment and place all parts on a non-abrasive surface.
These bed parts can be cumbersome and heavy; the assistance of two or more people is recommended in order to prevent
personal injury and ensure the bed is not damaged during the assembly process.
THADDEUS FORGED BRASS / IRON BED INSTRUCTIONS
PARTS INCLUDED HARDWARE INCLUDED
A
B
C
D
E
F
[1]
[1]
[2]
[1]
[1]
[1]
HEADBOARD
FOOTBOARD
SIDE RAILS
SET OF BED SLATS
SUPPORT SLAT
LEG
Threaded rod
Plain washer
Wrench
Hex nut
Lock washer
3
4
NO.
ITEM
DESCRIPTION QTY.
2
1
8 pcs.
8 pcs.
8 pcs.
5
8 pcs.
1 pc.
A. HEADBOARD
D. SET OF BED SLATS
C. SIDE RAILS
E. SUPPORT SLATS
F. LEG
B. FOOTBOARD
10/1/18

E
E
F
ASSEMBLY INSTRUCTIONS
1. Place the headboard (A) upright in the location you wish the bed
to be in when fully assembled. The headboard hardware should
be facing inside, toward the mattress. Secure the threaded rod (1)
to the fixed nut in the headboard (A) by simply turning it manually.
Raise the side rail (C) and set the rod (1) to align with the holes on
the end of the side rails (C). Position the side rails (C) against the
headboard (A) so the threaded rods (1) go through the holes.
Insert the plain washer (2) and lock washer (3), then engage
hexagonal nuts (4) on threaded rod (1) and tighten them with the
wrench (5), as illustrated in FIGURE 01.
2. Repeat the above procedure with the other side rail (C) to attach it
to the headboard (A), and then repeat to connect both side rails
(C) to the footboard (B).
NOTE: Tighten all the bolts to a snug fit.
3. Install the leg on the support slats (E) as shown in FIGURE 02.
Set the support slats (E) on the metal brackets of both headboard
(A) and footboard (B).
4. On inside face of both side rails (C) there is a cavity with wooden
stopper designed to hold the set of bed slats (D). Place bed slats
(D) on the side rails (C), with the last slat set on the wooden
stopper to hold the slats in place as shown in FIGURE 03.
CARE INSTRUCTIONS
•Hardware may loosen over time; periodically check that all
connections are tight, and tighten them if necessary.
•Wipe with a soft, dry cloth. To protect the finish, avoid the
use of any chemicals or household cleaners.
FIGURE 01
FIGURE 02
FIGURE 03
Thaddeus Bed - Page 2 of 2
10/1/18