RH LUCIDA DESK User manual

Thank you for choosing this quality product. Be sure to check all packaging materials carefully for small parts that may
have become loose during shipment and place all parts on a non-abrasive surface.
! WARNING: Desk parts can be cumbersome and heavy; therefore, the assistance of two or more
people is recommended in order to prevent personal injury and ensure the table is not damaged during the
assembly process.
PARTS INCLUDED
A [1] GLASS TOP
B [2] LEG FRAMES
ASSEMBLY INSTRUCTIONS
HARDWARE INCLUDED
NO. ITEM DESCRIPTION QTY.
1Headless Socket Screw Bolt 4 PCS
2Silicon Washer 4PCS
3Metal Washer 8PCS
4Allen Wrench 2PCS
1. A work bench or small, sturdy table is
required for assembly. Place the glass
top (A) onto the work bench or table.
Ensure the ends of the glass overhang
the bench.
2. In the hardware pack, locate the metal
washers (3) and silicon washers (2).
Place them in the cavities of the leg
frames, as shown in Figure 01.
3. Gently slide the cavity of the leg frames
(B) onto both ends of the glass top up to
the end of the protective film, as shown in
Figure 01.
4. After inserting the leg frames, remove the
desk from the work bench and set it on
the floor. IMPORTANT: Four or more
people are recommended when lifting the
desk.
FIGURE 01
METAL
WASHER
SILICON
WASHER
LUCIDA DESK INSTRUCTIONS
Page 1 of 2
11/1/18

Insert the remaining silicon washers between
the glass top and the leg frames, as shown in
Figure 02.
To keep the desk from wobbling, insert the
headless socket screw bolt (1) into the cavities
underneath the leg frames. Tighten all the bolts
with the Allen wrench (4) to a snug fit, as shown
in Figure 03-A.
Place the desk in the desired location and
check whether leveling is necessary. If so,
slightly tilt the desk and turn the levelers
clockwise to raise and counterclockwise to
lower, as shown in Figure 03-B. Repeat
adjustment procedures if necessary after the
furniture settles on rugs or on carpeted surface.
5.
6.
7.
FIGURE 02
SILICON
WASHER
FIGURE 03
FIGURE 03-A FIGURE 03-B
HEADLESS
SOCKET
SCREW
BOLT
11/1/18 Lucida Desk - Page 2 of 2