RHS HANBURY ARCH and PLANTERS User manual

Care and Maintenance
Your new garden item is a natural timber product. In order that you may
prolong the life of this product, we recommend that you follow the
general care and maintenance advice below.
All fixings to be checked for tightness and signs of deterioration at the
beginning of each season and on a regular basis.
We recommend that this product is positioned on firm level ground. If
necessary the product can be firmly fixed to the ground by using a
proprietary ground anchor.
The timber used in the product is pressure treated in accordance with BS
8417:2011 to provide protection against biodeterioration in end use
situations. It is possible that under some environmental conditions that a
surface mould may develop, should this happen clean off with mild
soapy water.
Product should be checked regularly, and re-coated with a suitable
topcoat finish when required. If accidental damage occurs, lightly sand
and re-coat with a suitable water based wood preservative. Product can
be cleaned periodically with a mild soapy detergent.
This is a natural product and therefore colour may vary slightly from
piece to piece. As a natural product it is possible that knots can work
loose and sometimes fall out, also resin leakage and small cracks can
appear on the woods surface. Should this happen, clean off resin, ensure
any sharp edges are sanded smooth and recoat.
Products should be given suitable protection from adverse weather
conditions, particularly during the winter months.
Please retain these instructions for future reference and use.
Helpline 01302 761573
Monday to Friday 9am - 5pm
HANBURY ARCH and PLANTERS
Contents
Components
Fixings
(1) 16 x 90mm Allen Screw
(2) 8 x 50mm Woodscrew
(3) 10 x 60mm Woodscrew
Pozi-drive screwdriver
Allen key (supplied)
(A) x2
(B) x2
(C) x2
(D) x2
(E) x8
Arch side
ASSEMBLY INSTRUCTIONS
Tools required
Planter front
Planter back
Planter side
Floor slat
(F) x2
Curved rail
(G) x5
Toprail
All manuals and user guides at all-guidesbox.com
all-guidesbox.com

Before you start:
Clear an area to build the product.
Identify parts and lay them out ready.
2 persons advised for assembly.
Site product on a clear level area.
�
�
�
�
1
4
(F)
2
Fixing (1) 90mm Allen Screw x8
(A)
(C)
(D)
(B)
(E)
Nails to inside
3
Repeat steps and to assemble second planter.
1
2
Ensure a pair of planters are made with logo details at front as below.
Fixing (2) 50mm Woodscrew x8
5
(F)
(G)
(G)
(G)
(G)
(G)
Fixing (3) 60mm Woodscrew x10
All manuals and user guides at all-guidesbox.com