Rinnai Symmetry Premium Flat User manual

Symmetry Premium Flat/
Square frame installation
Rinnai New Zealand Ltd. 0800 746 624
Rinnai Australia Pty. Ltd. 1300 555 545
Symmetry Premium Flat/Square Frame installation
12728-C (03:17)
Before fitting the frames and dress guard* ensure that the:
• glass panel is not damaged in any way
• rope seal gasket is seated correctly between the glass frame and the fire
• screws holding the glass frame to the spring loaded retainers have been
backed off a quarter of a turn (to prevent binding)
• glass frame moves freely on the spring loaded retainers
WARNING
b. c.
1 of 2
1Outer frame and
CAT5 cable 2Glass frame
3Flat front
1
Outer frame and CAT5 cable
a. Remove the top cover off the white PCB box.
b. Disconnect the CAT5 cable from the RJ45 connector inside the PCB box.
c. Connect the CAT5 cable on the manual switch, at the top right of the outer frame,
directly to the PCB as shown below, and refit the PCB cover.
d. Screw into position with the four screws provided. Cover the lower manual control
switch with the blanking sticker supplied with the frame.
* Optional accessory in NZ.

Rinnai New Zealand Ltd. 0800 746 624
Rinnai Australia Pty. Ltd. 1300 555 545
Symmetry Premium Flat/Square Frame installation
12728-C (03:17)
2 of 2
2
Glass frame
Remove the lower center screw in the glass frame and fit the free end of the wire lanyard as
shown below.
3
Inner flat/square frame
Fit the front so that the two top hooks are located over the top of the glass frame, and the
front sits against the magnets at the bottom of the frame.
When properly installed the front will swing out from the magnets and stop when the
lanyard becomes taut. When fitted the lanyard should be hidden in the channel between
the front and the glass frame.