ritetemp 6020 User manual

PG 1
PG 2
Statement of use: The 6020 can be used with millivolt,
24VAC, 1 and 2 stage conventional gas/oil/elec heat, 1 and 2
stage heat pumps, 2 or 3 wire zoned hot water, zoned forced
air, 1 and 2 stage cooling and hybrid systems. 
It cannot be used with 120 volt heating systems.
HEAT
HEAT
COOL
OFF
FAN
AUTO
ON
TEMP
UP button
TEMP DOWN button
Temperature
Display HEAT/COOL
Mode Switch
Fan
Switch
Configure
Set HEAT/COOL mode switch to HEAT or COOL. The unit will display the
Room temperature. Set the Fan switch to AUTO.
Press the TEMP UP and TEMP DOWN buttons to select the desired
temperature. The TARGET icon will be displayed with your desired
temperature. (Display will return to room temp in 5 sec).
In the winter, set the system switch to HEAT to control your heating system.
In the summer, set the system switch to COOL to control your AC.
In spring and fall or when windows are open, 
you can set the system switch OFF.
Setting the FAN switch to AUTO automatically runs your system's fan during
heating and cooling.
Setting the FAN switch to ON runs your system's fan continuously even
without heating or cooling.
Operate
Farenheit/Celcius
indicator
Current Temperature
Display SET Temperature
Display
ROOM TEMP TARGET TEMP
Operation 6020

PG 4
Celsius
jumper
Reset
button
Aux Only
Heat Pump
Customer Support: 877-505-2353 Visit our webiste
www.ritetemp-thermostats.com 1611-010
F
0
/ C
0
Select
The F/C jumper is under the top cover Jumper #5. It determines which
temperature system is displayed on the LCD display. With the jumper off, the
display is Fahrenheit (default setting), with the jumper on both pins, the
display is Centigrade. When the jumper is changed, the unit must be reset
(under the top cover on the left).
Low Battery
When the batteries are low, the battery icon will flash. The two AAA
batteries in the unit need to be replaced. The HVAC system will stop
functioning when the thermostat loses power; replace batteries as soon
as you see this warning. Press RESET after replacing batteries
If you have a heat pump with auxiliary heat, and the heat pump is not
working, you can use the auxiliary heat only by moving jumper 1 [heat pump]
to jumper position 2 [ Aux only].
1234567
To set a Heat Pump's Aux only mode