ritetemp 8025 User manual

PG 2
PG 1
1 Configure
2 Set Temp
3 Operate
.Set HEAT/COOL mode switch to HEAT or COOL. The unit will display the ambient  
 temperature. Set the Fan switch to automatic.
.Turn the Control Knob to increase or decrease the TARGET TEMP. The TARGET TEMP
will be displayed when your are adjusting the temp. (The display will return to show the
current ROOM TEMP in a few seconds).
.Your thermostat is now in operation.
In thewinter, set the HEAT-COOL Mode switch to HEAT to control your heating system.
In thesummer, set the HEAT-COOL Mode switch COOL to control your air conditioner.
In springandfall or when windows are open, you can set the HEAT/COOL Mode switch
to OFF.
Setting the FAN Mode switch to AUTO automatically runs yoursystem's fan during heating
and cooling.
Setting the FAN Mode switch to ON runs your system's fan continuously even without
heating or cooling.
O
F
F
O
N
A
U
T
O
H
E
A
T
C
O
O
L
F
A
N
H
E
A
T
C
O
O
L
F
A
N
C
O
O
L
E
R
W
A
R
M
E
R
HEAT
ROOM TEMP
Temperature
Display
HEAT/COOL
Mode Switch
Control Knob
Fan Mode
Switch
Operation 8025
Statement of use: The 8025 can be used with: most 24 volt
gas, oil or electric heating and air conditioning systems,
single-stage heat pumps or gas millivolt heating systems.It
cannot be used with 120 volt heating systems or
multistage heat pumps.

Inside of Unit
OFF
ON
RESET
GAS
ELEC
SHORT C
OPEN F
4 Special Features
PG 3
PG4
Celsius/Fahrenheit
(C/F) jumper
Reset Button
Gas/Electric
jumper
C/F Select
Centigrade / Fahrenheit selection. The C/F jumper is on theback of the
thermostat control unit it determines which temperature system is displayed on the
LCD display.
.To change the
oF / oC jumper. Separate the control unit from the wall mounted 
 terminals.
.Locate the
oF / oC jumper.
.Select the desired display mode.
.Press the internal RESET button and replace the control uniton the wall.
When the batteries are low, the battery icon will come on and flash.The
two AA Batteries in the unit need to be replaced. In some installations,
your heater system will stop functioning when the thermostst loses power. Replace
Batteries as soon as you see this warning. The thermostat setting will remain for 30
seconds while the batteries are removed and replaced.
Customer Support: 888-515-2585
Visit our website www.ritetemp-thermostats.com
Rear View of Unit
Low Battery
1-403-019