Riverside Furniture Mix-N-Match 36964 User manual

5/16" Spring Washer
4 pcs.
M5/16" x 1 1/2"
Allen Head Bolt M5/16" x 2"
Allen Head Bolt
Components and Hardware List (for one chair)
M5/16" x 3"
Allen Head Bolt
5mm Allen Wrench
4 pcs.
1 pc.
Riverside
FURNITURE Made in China
Page 1 of 2
1 pc.
Chair Seat
1 pc. 2 pcs.
Front Leg
(Right & Left) Side Stretcher
(Right & Left) Middle Stretcher
2 pcs. 1 pc.
Mix-N-Match
Dining Chairs
Assembly Instructions
9pcs.
Chair Back
1 pc.
1 pc.
Fabric Cover

NOTE: THE SLIP COVER IS 100% LINEN AND MAY BE STEAMED OR IRONED ON A LINEN HEAT
SETTING TO HELP REMOVE WRINKLES IF NEEDED.
Step 5: Assemble the Fabric Cover to the chair as shown
below.
A. Pull the Slip Cover over the top of the chair back and pull
down snug to the back. There is a fabric tab sewn across the
bottom side at the seam of the slip cover where the back
and seat come together. Before pulling the cover over the
chair seat, tuck the fabric tab into the joint where the chair
back and seat cushions meet, to create a 'seam' in the slip
cover at the back of the seat.
B. Lower the slip cover skirt down, covering the seat and chair
legs.