Riverside Furniture 24530 User manual

Bristol Court
Executive Desk
Assembly Instructions
Made in China
Page 1of 2
Parts List
#24530
Executive Desk
WARNING
ASSEMBLY STEPS :
1. Place the Desk upside down on a clean, soft
surface such as a blanket or carpet.
2. Using your Phillips Screwdriver, remove the
wood brace from underneath the desk and
discard.
3. Attach the Bun Feet with the levelers
underneath the front corners and with no
levelers underneath the back corners of both
Pedestals.
4. If required, the levelers can be adjusted to
compensate for uneven flooring. After
moving the Desk to it's final location in the
room, using two people, have one person
gently lift the front of the desk while another
person carefully reaches underneath and
adjusts the levelers.
5. Install the Grommet (B) into the hole in the
Desk Top.
B
Grommet
1 pc
FURNITURE
Riverside
email: [email protected]
A
Bun Feet
8 pcs
3/8" Long Wood
Screw (installed)
E8 pcs
Figure 8
(installed)
C8 pcs
Keys
F2 pcs
C
DE
A
F
6. The File drawers can be set-up to use
either Letter size or Legal size folders
using the File Bars included.
File Bar
(installed)
4 pcs
D
G4 pcs H1 pc
Pencil Tray
Divider
(installed)
The Dividers are
installed in these
two drawers.

Bristol Court
Executive Desk
Assembly Instructions
Made in China
Page 2 of 2
FURNITURE
Riverside
email: [email protected]
The power cord from the electrical outlet
mounted inside the knee drawer has been
pre-routed from the knee drawer out to and
secured underneath the bottom side of the
Right-Hand pedestal, which can then be
connected to a wall outlet.
If you want to exit the cord from the left
pedestal, you may need to remove the
drawers from both pedestals in order to
change or re-route the power cord from one
side to the other. Do not apply excessive force
to the cord while pulling the cord through the
access holes.
To release
drawer slide
To remove the drawer:
A. Pull the drawer fully open so the black latch is visible in the inside channel of the guides.
B. Release the latches by simultaneously pushing one lever up and the other down.
C. At the same time, pulling the drawer forward until the slides release. If necessary, empty
drawer before removing.
To Reinstall Drawer:
A. Carefully reinstall the drawer by aligning the channels on the drawer with the ball
bearings in the channels of the cabinet members and gently pushing the drawer closed.
B. Carefully open the drawer to verify it is working properly.